If the eccentricity ratio is more than 1/24, then increase in the per – McqOptions

MCQOPTIONS

1.	If the eccentricity ratio is more than 1/24, then increase in the permissible stress in the design of wall subjected to eccentric loading as per code is
A.	10 %
B.	25 %
C.	50 %
Answer» C. 50 %

Discussion

No Comment Found

Related MCQs

For strengthening a 50 m long and 5 m high straight compound wall built in brick work, which one of the following would be most suitable?
Minimum thickness of stiffening wall for 1 to 3 storeys shall not be less than
If the horizontal cross-sectional area of a wall is 1200 cmÂ², then the basic stress shall be multiplied by a reduction factor equal to
Direct load carrying capacity of a brick masonry wall standing freely as against when it supports RC slab will be
Minimum compressive strength in N/mmÂ² for H1 type mortar used for masonry is
The thickness of each leaf of a cavity wall shall not be less than
For masonry built in 1 : 1 : 6 cement-lime-sand mix mortar or equivalent, the horizontal shear stress permissible on the area of a mortar bed joint is
For masonry work with solid bricks, consistency of mortar should be
If the eccentricity ratio is more than 1/24, then increase in the permissible stress in the design of wall subjected to eccentric loading as per code is
If the ratio of center to center spacing of intersecting walls to actual thickness of intersecting wall is more than 20, then the stiffening coefficient for wall proper will be