If_the_coefficient_of_friction_is_0.43,_and_the_design_velocity_is_40k – McqOptions

MCQOPTIONS

1.	If_the_coefficient_of_friction_is_0.43,_and_the_design_velocity_is_40kmph_then_the_radius_of_curve_is$
A.	20m
B.	25m
C.	28m
D.	30m
Answer» E.

Discussion

No Comment Found

Related MCQs

The capacity of rotary in PCU per hour for a proportion of weaving traffic 0.5 and the width of weaving section is 12m, average width of entry is 0.4m and length of the weaving section is 7.2m.
In a traffic lane the traffic moving extreme left is 250 PCU and in extreme right it is 240 PCU, the sum of the weaving traffic crossing left and right is 500 PCU, find proportion of weaving traffic.
The PCU value near rotary is highest for __________
If the average width of the entry section is 3m and the exit is 6m then the average width is?
The minimum radius for rotary recommended by IRC is?
If the coefficient of friction is 0.43, and the design velocity is 40kmph then the radius of curve is?
In India the design velocity at rotary is considered as __________
The procedure of adopting medians and traffic island in an un-channelized intersection is called __________
The most complex type of intersections for traffic operation is __________
Which of the following is not a requirement for the intersection at grade?