For the circuit shown below, T1 and T2 (from top T1 and T2) are both – McqOptions

MCQOPTIONS

1.	For the circuit shown below, T1 and T2 (from top T1 and T2) are both fired at an angle α. Then from ωt = π to ωt = π+α
A.	None of the devices conduct
B.	T1 and one diode will conduct
C.	T2 and one diode will conduct
D.	Both the diodes will conduct
Answer» E.

Discussion

No Comment Found

Related MCQs

For the same triggering angle and ratings
A single-phase semi-converter circuit is supplying power to a motor load. The average value of load voltage is 176.72 V and the rms value is 219.3 V. Find the VRF (voltage ripple factor).
A single-phase semi-converter is connected to a 230 V source and is feeding a load R = 10 Ω in series with a large inductance that makes the load current ripple free. For α = 45°, find the rectification efficiency. The RMS value of output voltage is 219.3 V
A single-phase semi-converter is connected to a 230 V source and is feeding a load R = 10 Ω in series with a large inductance that makes the load current ripple free. Find the average output current for α = 45°.
In any AC-DC circuit, the freewheeling action
For the circuit shown below, T1 and T2 (from top T1 and T2) are both fired at an angle α. Then from ωt = π to ωt = π+α
Find the circuit turn-off time (Tc) for the below given semi-converter configuration. Take α = 30° and Vs = 230√2 sin100t
In the below given circuit, from ωt = π to α+π and continuous load current configuration
A single-phase asymmetrical semi-converter employs
A single-phase symmetrical semi-converter employs