For an S-R flip-flop to be SET or RESET, the respective input must be – McqOptions

MCQOPTIONS

1.	For an S-R flip-flop to be SET or RESET, the respective input must be __________.
A.	LOW
B.	HIGH
C.	installed with steering diodes
D.	in parallel with a limiting resistor
Answer» C. installed with steering diodes

Discussion

No Comment Found

Related MCQs

One example of the use of an S-R flip-flop is as a(n) _________.
When using master-slave flip-flops, the data is entered into the flip-flop on the leading edge of the clock, but the output does not change until the trailing edge of the clock.
For an S-R flip-flop to be SET or RESET, the respective input must be __________.
If an input is activated by a signal transition, it is _____________.
The toggle condition in a master-slave J-K flip-flop means that Q and will switch to their ________ state(s) at the _____________________.
A D-type flip-flop is constructed by connecting an inverter between the Set and Clock terminals.
When the S and the R inputs are both HIGH the output of an S-R NOR latch will be unpredictable.
An astable multivibrator is a circuit that:
Edge-triggered flip-flops must have _________.
The S-R, D-type, and J-K flip-flops are all examples of _________________.