Consider a circuit as shown in figureThe circuit is(1) Constant K low-pass filter(2) Constant K high-pass filter(3) The m-derived low-pass filter(4) The m-derived high-pass filter

Consider a circuit as shown in figureThe circuit is(1) Constant K low-

1.	Consider a circuit as shown in figureThe circuit is(1) Constant K low-pass filter(2) Constant K high-pass filter(3) The m-derived low-pass filter(4) The m-derived high-pass filter
A.	1
B.	2
C.	3
D.	4
Answer» B. 2

Discussion

No Comment Found

Related MCQs

A signal of 1 kHz is to be amplified, but the circuit board and wires pick up and store a 60 Hz component from a nearby electric line. If this component is 40 dB higher than the desired signal, what filter stopband attenuation is necessary to ensure the signal remains 20 dB above the interference level?
Consider the following circuits:(a) Integrating circuit(b) Active differentiation circuit(c) Notch type electrical filterArrange the above circuit models in decreasing order of their complexity.
A low-pass filter with a cut-off frequency of 30 Hz is cascaded with a high pass filter with a cut-off frequency of 20 Hz. The resultant system of filters will function as
In a simple high pass RC filter if the value of the capacitor is doubled, the cut-off frequency is
Consider a circuit as shown in figureThe circuit is(1) Constant K low-pass filter(2) Constant K high-pass filter(3) The m-derived low-pass filter(4) The m-derived high-pass filter
A filter having two passbands separated by a small frequency band of zero output is of the type ________.
A system transfer function is \(H\left( s \right) = \frac{{{a_1}{s^2} + {b_1}s + {c_1}}}{{{a_2}{s^2} + {b_2}s + {c_2}}}\). If a1 = b1 = 0, and all other coefficients are positive, the transfer function represents a
If τ is time constant and ω is the applied frequency, a low pass RC filter acts as a pure integrator when
A RC high pass filter acts as differentiator when ______.
In case of a high-pass filter, the transfer function should be with1) 1 pole and 1 zero2) 2 poles and 2 zero3) 2 poles and 1 zeroWhich of the above are correct?

Consider a circuit as shown in figureThe circuit is(1) Constant K low-pass filter(2) Constant K high-pass filter(3) The m-derived low-pass filter(4) The m-derived high-pass filter

Discussion

No Comment Found

Related MCQs

Reply to Comment