An RLC series circuit has Q = 100 and 0 = 20 rad/sec. The bandwidth i – McqOptions

MCQOPTIONS

1.	An RLC series circuit has Q = 100 and ₀ = 20 rad/sec. The bandwidth is ____________
A.	0.2 rad/sec
B.	2 rad/sec
C.	20 rad/sec
D.	2000 rad/sec
Answer» B. 2 rad/sec

Discussion

No Comment Found

Related MCQs

M(t) = 2, 0 t<4;<br> t<sup>2</sup>, t 4;
The Current Transformer supplies current to the current coil of a power factor meter, energy meter and, an ammeter. These are connected as?
For any given signal, average power in its 8 harmonic components as 50 mW each and fundamental component also has 50 mV power. Then, average power in the periodic signal is _______________
Two similar coils have self-inductance of 20 mH each. Coefficient of coupling is 0.4. The mutual inductance M is ______________
An RLC series circuit has R = 7.07 , L = .707 H and C = 7.07 F. At Half power frequencies the circuit impedance is ___________
A coil has resistance R and inductance L. At = the phase angle between voltage and current is _____________
In a two terminals network the open circuit voltage measured at the given terminals is 110 V and short circuit currents at the same terminals 10 A. If a load of 50 resistance is connected at the terminals, load current is ___________
Poles and zeros of a driving point function of a network are simple and alternate on j axis. The network consists of ___________
In an unloaded transformer, the flux limiting the primary is 10 mWb and secondary is 30 mWb. The coefficient of coupling is ____________
An RLC series circuit has Q = 100 and <sub>0</sub> = 20 rad/sec. The bandwidth is ____________