According to IS 456, when high strength deformed bars are used, the re – McqOptions

MCQOPTIONS

1.	According to IS 456, when high strength deformed bars are used, the reinforcement shall not be less than p percent of the total cross sectional area of the slab, where p is
A.	0.12
B.	0.15
C.	0.1
D.	0.09
E.	0.16
Answer» B. 0.15

Discussion

No Comment Found

Related MCQs

In reinforced brickwork slabs, the diameter of main reinforcement shall, preferable not exceed
In case of a non-cellular, non-ribbed flat slab, the spacing of the steel reinforcing bars shall not exceed m times the thickness of the slab, wherein m is
In absence of detailed design, approximately how much percentage for steel reinforcement may be considered for estimation of RCC lintels
According to IS 456 : 2000, the maximum diameter of reinforcing bars shall not exceed
A rectangular beam 200 mm wide has an effective depth of 350 mm. It is subjected to a bending moment of 24,000 Nm. The permissible stresses are c = 5 N/mm2, t = 140 N/mm2; and m is 18. The required area of tensile reinforcement will be
Maximum horizontal distance between parallel main reinforcement bars in tension in RC slabs (according to IS 456:2000) shall not be :Take d = effective depth of solid slab
According to IS 3414, the recommended spacing of expansion joints for thin unprotected slabs is
A reinforced concrete cantilever porch has thickness t. The main reinforcement steel will be placed:
According to IS 456, when high strength deformed bars are used, the reinforcement shall not be less than p percent of the total cross sectional area of the slab, where p is
Minimum area of tension reinforcement in a beam shall be greater than:-