A voltage is defined by \(v(t)=\begin{cases}0\\2t\\4e^{-(t-2)}\\\end{ – McqOptions

MCQOPTIONS

1.	A voltage is defined by \(v(t)=\begin{cases}0\\2t\\4e^{-(t-2)}\\\end{cases} \) for \(\begin{cases}t < 0 \\02s \\\end{cases} \) respectivelyand is applied to the 10 µF capacitor. Which of the following is incorrect?
A.	i = 0 for t < 0
B.	i = 20µA for 0 < t < 2s
C.	i = 40et-2µA for t > 2s
D.	i = -40et-2µA for t > 2s
Answer» D. i = -40et-2µA for t > 2s

Discussion

No Comment Found

Related MCQs

A voltage is defined by \(v(t)=\begin{cases}0\\2t\\4e^{-(t-2)}\\\end{cases} \) for \(\begin{cases}t < 0 \\0<t<2s \\t>2s \\\end{cases} \) respectivelyand is applied to the 10 µF capacitor. Which of the following is incorrect?
Which of the following is not the energy stored in a capacitor?
The capacitance of a capacitor does not depend on the absolute permittivity of the medium between the plates.
An inductor of 3mH has a current i = 5(1 – e-5000t). Find the corresponding maximum energy stored.
Energy stored in an inductor is ________
Inductance of an inductor is inversely proportional to its ___________
Unit of inductance is ________
A 25 Ω resistor has a voltage of 150 sin377 t. Find the corresponding power.
Resistance depends on the temperature of the conductor.
A conductor is said to have resistance of one ohm if a potential difference of one volt across its terminals causes a current of X ampere to flow through it. What will be the value of X?