A material for permanent magnet should have – McqOptions

MCQOPTIONS

1.	A material for permanent magnet should have
A.	High retentivity
B.	High permeability
C.	Low hysteresis loss
D.	High hysteresis loss
Answer» B. High permeability

Discussion

No Comment Found

Related MCQs

For a high pass filter, β = p in attenuation band.
In attenuation band, β is an odd multiple of p.
For a series RLC circuit bandwidth is ω2 - ω1 = R/2L.
In a series RC circuit Z = (R2 + ω2C2)0.5.
As per Euler's identity ejωt = cos ωt + j sin ωt
μ0 = 8.85 x 10-12F/m.
Resistivity of semiconductors is around 100 &ohm;-m.
Assertion (A): In series R-L-C circuit, the current may lead or lag the voltage depending on the value of R.Reason (R): Phase angle of an R-L series circuit is tan-1 (ωL/R).
Assertion (A): If A = 0.5 ∠ 20°, A2 = 0.25 ∠ 40°.Reason (R): When drawing a phasor diagram, sinusoids may have the same or different frequencies.
Assertion (A): When capacitor is fed by a dc voltage given a capacitor behaves as short circuit at t = 0 and open circuit at f = ∞.Reason (R): The impedance of a capacitor is