Explore topic-wise MCQs in Networking.

This section includes 310 Mcqs, each offering curated multiple-choice questions to sharpen your Networking knowledge and support exam preparation. Choose a topic below to get started.

151.

Which of the following statement is correct?

A. A spin stabilized satellite uses solar panels whose cells are continually oriented toward the sun
B. satellite transponders use a single frequency for reception and transmission from one point on earth to another
C. A spin stabilized satellite uses solar panels whose cells are continually oriented toward the sun
D. A spin stabilized satellite used solar cells mounted on a cylinder body that continuously rotates so that 40 a time and it also uses gyroscopic action of a spinning satellite to maintain its orientation towards the earth and the sun
Answer» E.
152.

The connector that is used for connecting cable to networking devices is called

A. subscriber channel (SC)
B. straight-tip (ST)
C. MT-RJ
D. None of them
Answer» C. MT-RJ
153.

Data communications are the transfer of data through some

A. transmission medium
B. linear medium
C. Network LAN
D. Protocols
Answer» B. linear medium
154.

The term that is used for physical path by which a message travels from sender to receiver is

A. Jitter
B. Protocol
C. Transmission Medium
D. Information
Answer» D. Information
155.

Maximum number of characters or symbols that can be represented by Unicode

A. 24
B. 26
C. 216
D. 232
Answer» E.
156.

A telephone line cannot pass frequencies below

A. 800Hz
B. 600HZ
C. 400Hz
D. 200Hz
Answer» E.
157.

The existing local loops with Asymmetric Digital Subscriber Line (ADSL) can handle bandwidths up to

A. 1.1 Hz
B. 1.1 KHz
C. 1.1 MHz
D. 1.1GHz
Answer» D. 1.1GHz
158.

The total bandwidth required for Amplitude Modulation (AM) is

A. 2B
B. 2(1 + β)B.
C. 2L
D. 2F
Answer» B. 2(1 + β)B.
159.

Asynchronous, synchronous and isochronous are three subclasses of serial transmission to send

A. parallel data
B. discrete data
C. Continuous data
D. None
Answer» B. discrete data
160.

Delivering data to the correct destination is

A. Delivery
B. Accuracy
C. Timelessness
D. Jitter
Answer» B. Accuracy
161.

Protocols are, set of rules to govern

A. Communication
B. Standards
C. Metropolitan communication
D. None of Above
Answer» B. Standards
162.

The Asymmetric DSL is used the line code of

A. DMT
B. 2B1Q
C. T-1line
D. None of them
Answer» B. 2B1Q
163.

In real life, most digital signals have bandwidth

A. infinite
B. Zero
C. Constant
D. None of the Above
Answer» B. Zero
164.

The unit of the signal rate is

A. Bits per second
B. Baud
C. micro seconds
D. Hertz
Answer» C. micro seconds
165.

Signal rate is also called the

A. Pulse rate
B. modulation rate
C. baud rate.
D. All of the above
Answer» E.
166.

Diameter of fiber optic cable is

A. 62.5 cm
B. 62.5 microns
C. 62.5 m
D. 62.5 mm
Answer» C. 62.5 m
167.

Propagation of light is

A. unidirectional
B. bidirectional
C. multimode
D. single mode
Answer» B. bidirectional
168.

The twisted pair cable consists of

A. none
B. 1 conductor
C. 2 conductors
D. n conductors
Answer» D. n conductors
169.

The channels can be shared in an area with many subscribers with the help of

A. multi casting
B. frequency sharing
C. data sharing
D. time sharing
Answer» E.
170.

How many communication channels are needed for serial transmission?

A. 1 channel
B. n channels
C. n+1 channels
D. None of the above
Answer» B. n channels
171.

The value of the error for any sample is less than

A. 4Δ
B. 2Δ
C. Δ
D. Δ/2
Answer» E.
172.

The word Tele means

A. Far
B. Near
C. Apart
D. Beside
Answer» B. Near
173.

An Asymmetric Digital Subscriber Line (ADSL) is not suitable for

A. games
B. businesses
C. residential users
D. downloading
Answer» C. residential users
174.

A system is using NRZ-I to transfer 10-Mbps data. What would be minimum bandwidth

A. 500 kHz.
B. 1000 KHz
C. 2000 KHz
D. 5000 KHz
Answer» B. 1000 KHz
175.

In 8B6T, the minimum bandwidth is very close to

A. 2BIQ
B. 8B4Q.
C. 6N18
D. MLT-3
Answer» D. MLT-3
176.

The tasks of data transfer and signaling are separated in modern

A. data transfer network
B. signaling network
C. radio networks
D. telephone networks
Answer» E.
177.

In data over cable system interface specification, the downstream communication has only one

A. send
B. receiver
C. channel
D. media
Answer» B. receiver
178.

DSL stands for

A. digital subscriber line
B. digital switched line
C. data subscriber line
D. data switched line
Answer» B. digital switched line
179.

MTP stands for

A. Message transfer port
B. Message telephone port
C. message telephone part
D. message transport part
Answer» E.
180.

Multilevel Amplitude Shift Keying (MASK) is not implemented with pure Amplitude Shift Keying (ASK), it is implemented with

A. QAM
B. PSK
C. FSK
D. Binary ASK
Answer» B. PSK
181.

The theoretical upstream data rate in QPSK is

A. 12 Mbps
B. 14 Mbps
C. 18 Mbps
D. 20 Mbps
Answer» B. 14 Mbps
182.

The twisted pair cable in which metal casing improves the penetration of noise or crosstalk is called

A. insulated twisted pair cable
B. Shielded twisted pair cable
C. Unshielded twisted pair cable
D. Both a and b
Answer» C. Unshielded twisted pair cable
183.

The idea of Return to Zero (RZ) and Non Return to Zero-Level (NRZ-L) are combined into the

A. Manchester
B. Differential Manchester
C. Multilevel bipolar transition
D. Multi transition scheme
Answer» B. Differential Manchester
184.

The minimum bandwidth of the digital signal is nb times greater than the bandwidth of the

A. analog signal
B. digital data
C. analog data
D. None of the above
Answer» B. digital data
185.

The radio waves, micro- waves and infrared waves are types of

A. wireless transmission
B. guided transmission
C. both a and b
D. None
Answer» B. guided transmission
186.

The projection of the point on the X axis defines the peak amplitude of the

A. above phase
B. below phase
C. in phase
D. out of phase
Answer» D. out of phase
187.

Data encoding is not possible if

A. 2m<Ln
B. 2m> Ln
C. 2m=Ln
D. 2m>=Ln
Answer» C. 2m=Ln
188.

A no periodic signal has changed to a periodic signal with the period equal to

A. 2 times the bit duration
B. 4 times the bit duration
C. 8 times the bit duration
D. 12 times the bit duration
Answer» C. 8 times the bit duration
189.

Guided media provides a conduit from one device to another, includes

A. twisted pair cable
B. fiber optic cable
C. coaxial cable
D. All of the above
Answer» E.
190.

The most common unshielded twisted pair connector is

A. RJ-45
B. RG-59
C. RG-58
D. RG-ll
Answer» B. RG-59
191.

The maximum data rate of 64 kbps is of

A. 800 service
B. 900 service
C. Digital data service
D. analog leased line
Answer» D. analog leased line
192.

Shielded Screen Twisted pair decreases crosstalk effect and increases the data rate upto

A. 100Mbps
B. 125Mbps
C. 200Mbps
D. 600Mbps
Answer» E.
193.

Infrared waves are used for

A. outdoor LANs
B. indoor LANs
C. Wireless LANs
D. satellite
Answer» C. Wireless LANs
194.

If a subscriber needs to provide free connections for other subscribers, it can request the

A. 800 service
B. 900 service
C. wide-area telephone service
D. digital data service
Answer» B. 900 service
195.

In line-or-sight propagation, very high-frequency signals are transmitted in straight lines directly from antenna to

A. sky
B. earth
C. antenna
D. planet
Answer» D. planet
196.

The Asymmetric Digital Subscriber Line- Lite (ADSL Lite) uses carriers for

A. 512 DMT
B. 64 DMT
C. 256 DMT
D. 900 DMT
Answer» D. 900 DMT
197.

The electromagnetic waves ranging in frequencies between 3 kHz and 1 GHz are called

A. High frequency
B. Infrared
C. Microwaves
D. radio waves
Answer» E.
198.

The term that refers to the phase continues through the boundary of two signal elements is

A. non coherent BFSK
B. coherent BFSK
C. Binary ASK
D. Multilevel ASK
Answer» C. Binary ASK
199.

The transmission media that handle the communication between offices is called

A. local loops
B. Trunks
C. LATA
D. local service exchange
Answer» C. LATA
200.

The most common technique to change an analog signal to digital data is called

A. Line code modulation
B. Scrambling
C. Block code modulation
D. pulse code modulation
Answer» E.