MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 10 Mcqs, each offering curated multiple-choice questions to sharpen your Manufacturing Engineering knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
WHICH_OF_THE_FOLLOWING_ELECTRODE_HAS_VERY_HIGH_ELECTRICAL_CONDUCTIVITY_BUT_LOW_STRENGTH??$ |
| A. | Copper chromium alloys |
| B. | Copper cobalt alloys |
| C. | Copper beryllium alloys |
| D. | Copper cadmium alloys |
| Answer» E. | |
| 2. |
Which of the following electrode has low electrical conductivity but higher strength?$ |
| A. | Copper chromium alloys |
| B. | Copper cobalt alloys |
| C. | Copper beryllium alloys |
| D. | Copper cadmium alloys |
| Answer» B. Copper cobalt alloys | |
| 3. |
According to the joules law? |
| A. | The poor conductor heats up to a higher degree than a good conductor |
| B. | The poor conductor heats up to a lower degree than a good conductor |
| C. | The poor conductor heats up to equal degree than a good conductor |
| D. | None of the Mentioned |
| Answer» B. The poor conductor heats up to a lower degree than a good conductor | |
| 4. |
Which of the following is true about resistance welding? |
| A. | Electrodes of higher resistivity is used for lower resistive piece |
| B. | Electrodes of higher resistivity is used for higher resistive piece |
| C. | Electrodes of lower resistivity is used for lower resistive piece |
| D. | None of the Mentioned |
| Answer» B. Electrodes of higher resistivity is used for higher resistive piece | |
| 5. |
Which of the following is true about electrodes? |
| A. | Low electrical conductivity and low mechanical strength |
| B. | Low electrical conductivity and high mechanical strength |
| C. | High electrical conductivity and low mechanical strength |
| D. | High electrical conductivity and high mechanical strength |
| Answer» E. | |
| 6. |
If 20 amperes of current are flowing in the wire for 1 minute of time having a resistance of 1000 ohm. Then the amount of heat generated in resistance welding in kilo joules will be? |
| A. | 24000 |
| B. | 240000 |
| C. | 24000000 |
| D. | 2400 |
| Answer» B. 240000 | |
| 7. |
Resistance is composed of: |
| A. | Resistance of electrode |
| B. | Contact resistance between electrode and work piece |
| C. | Contact resistance between two work piece plates |
| D. | Resistance of work piece |
| Answer» E. | |
| 8. |
In which of the following welding process heat and pressure is applied on the joint but no filler material of flux is added? |
| A. | Arc welding |
| B. | Resistance welding |
| C. | Gas welding |
| D. | Thermite welding |
| Answer» C. Gas welding | |
| 9. |
Which of the following is used to produce heat in the welding process? |
| A. | Electric arc |
| B. | Chemical flame |
| C. | Electric resistance heating |
| D. | All of the Mentioned |
| Answer» E. | |
| 10. |
Which of the following is not true about fusion welding? |
| A. | It depends upon the characteristics of heat source. |
| B. | It depends upon the nature of deposition of the filler material |
| C. | It does not depend upon the heat flow characteristics in the joint |
| D. | It depends upon the gas metal or slag metal reaction |
| Answer» D. It depends upon the gas metal or slag metal reaction | |