

MCQOPTIONS
Saved Bookmarks
This section includes 368 Mcqs, each offering curated multiple-choice questions to sharpen your Mechanical Engineering knowledge and support exam preparation. Choose a topic below to get started.
351. |
In a domestic refrigerator, a capillary tube controls the flow of refrigerant from the |
A. | Expansion valve to the evaporator |
B. | Evaporator to the thermostat |
C. | Condenser to the expansion valve |
D. | Condenser to the evaporator |
Answer» B. Evaporator to the thermostat | |
352. |
Nusselt number (NN) is given by |
A. | NN = hl/k |
B. | NN = μ cp/k |
C. | NN = ρ V l /μ |
D. | NN = V²/t.cp |
Answer» B. NN = ≈í¬∫ cp/k | |
353. |
In vapour compression refrigeration system, refrigerant occurs as liquid between |
A. | Condenser and expansion valve |
B. | Compressor and evaporator |
C. | Expansion valve and evaporator |
D. | Compressor and condenser |
Answer» D. Compressor and condenser | |
354. |
Superheating in a refrigeration cycle |
A. | Increases C.O.P |
B. | Decreases C.O.P |
C. | C.O.P remains unaltered |
D. | Other factors decide C.O.P |
Answer» C. C.O.P remains unaltered | |
355. |
The conditioned air supplied to the room must have the capacity to take up |
A. | Room sensible heat load only |
B. | Room latent heat load only |
C. | Both room sensible heat and latent heat loads |
D. | None of the above |
Answer» D. None of the above | |
356. |
In mechanical refrigeration system, the refrigerant has the maximum temperature |
A. | In evaporator |
B. | Before expansion valve |
C. | Between compressor and condenser |
D. | Between condenser and evaporator |
Answer» D. Between condenser and evaporator | |
357. |
In vapour compression cycle using NH‚ÇÉ as refrigerant, initial charge is filled at# |
A. | Suction of compressor |
B. | Delivery of compressor |
C. | High pressure side close to receiver |
D. | Low pressure side near receiver |
Answer» D. Low pressure side near receiver | |
358. |
When the lower temperature of a refrigerating machine is fixed, then the coefficient of performance can be improved by |
A. | Operating the machine at higher speeds |
B. | Operating the machine at lower speeds |
C. | Raising the higher temperature |
D. | Lowering the higher temperature |
Answer» E. | |
359. |
An infinite parallel planes with emissivities e‚ÇÅ and e‚ÇÇ, the interchange factor for radiation from surface 1 to surface 2 is given by# |
A. | (e‚ÇÅ + e‚ÇÇ)/ e‚ÇÅ + e‚ÇÇ - e‚ÇÅe‚ÇÇ |
B. | 1/e‚ÇÅ + 1/e‚ÇÇ |
C. | e‚ÇÅ + e‚ÇÇ |
D. | e‚ÇÅe‚ÇÇ |
Answer» B. 1/e‚Äö√á√Ö + 1/e‚Äö√á√á | |
360. |
In a refrigerating machine, heat rejected is _________ heat absorbed. |
A. | Equal to |
B. | Less than |
C. | Greater than |
D. | None of these |
Answer» D. None of these | |
361. |
Highest pressure encountered in a refrigeration system should be |
A. | Critical pressure of refrigerant |
B. | Much below critical pressure |
C. | Much above critical pressure |
D. | Near critical pressure |
Answer» C. Much above critical pressure | |
362. |
In vapour compression cycle, the condition of refrigerant is high pressure saturated liquid |
A. | After passing through the condenser |
B. | Before passing through the condenser |
C. | After passing through the expansion or throttle valve |
D. | Before entering the expansion valve |
Answer» E. | |
363. |
An important characteristic of absorption system of refrigeration is |
A. | noisy operation |
B. | quiet operation |
C. | cooling below 0°C |
D. | very little power consumption |
Answer» C. cooling below 0¬¨‚àûC | |
364. |
During a refrigeration cycle, heat is rejected by the refrigerant in a |
A. | Compressor |
B. | Condenser |
C. | Evaporator |
D. | Expansion valve |
Answer» C. Evaporator | |
365. |
A refrigeration cycle operates between condenser temperature of + 27°C and evaporator temperature of -23°C. The Carnot coefficient of performance of cycle will be# |
A. | 0.2 |
B. | 1.2 |
C. | 5 |
D. | 6 |
Answer» D. 6 | |
366. |
The value of C.O.P in vapour compression cycle is usually |
A. | Always less than unity |
B. | Always more than unity |
C. | Equal to unity |
D. | Any one of the above |
Answer» C. Equal to unity | |
367. |
During cooling and dehumidification, dry bulb temperature |
A. | Remains constant |
B. | Increases |
C. | Decreases |
D. | None of these |
Answer» D. None of these | |
368. |
Cooling water is required for following equipment in ammonia absorption plant |
A. | Condenser |
B. | Evaporator |
C. | Absorber |
D. | Condenser, absorber and separator (rectifier) |
Answer» E. | |