Explore topic-wise MCQs in Mechanical Engineering.

This section includes 150 Mcqs, each offering curated multiple-choice questions to sharpen your Mechanical Engineering knowledge and support exam preparation. Choose a topic below to get started.

1.

A nuclear fission is initiated when the critical energy as compared to neutron binding energy of the atoms is%!

A. Same
B. More
C. Less
D. There is no such criterion
Answer» C. Less
2.

A nuclear fission produces energy of following order in MeV%!

A. 20
B. 200
C. 2000
D. 20,000
Answer» C. 2000
3.

The predominant isotope of the naturally occurring element is%!

A. U₂₃₅
B. U‚Äö√á√á‚Äö√á√â‚Äö√á√
C. Pu₂₃₃
D. Pu₂₃₉
Answer» C. Pu‚Äö√á√á‚Äö√á√â‚Äö√á√â
4.

Hydrogen is preferred as better coolant in comparison to CO‚ÇÇ because former%!

A. Is lighter
B. Is inert
C. Has high specific heat
D. Is a good conductor
Answer» D. Is a good conductor
5.

The efficiency of a nuclear power plant in comparison to conventional and nuclear consideration is%!

A. Higher cost of nuclear fuel
B. High initial cost
C. High heat rejection in condenser
D. Lower temperature and pressure conditions
Answer» E.
6.

Which of the following is the heaviest?%!

A. Neutron
B. Proton
C. Atom
D. Electron
Answer» D. Electron
7.

A nuclear unit becoming critical means%!

A. It is generating power to rated capacity
B. It is capable of generating much more than rated capacity
C. There is danger of nuclear spread
D. Chain reaction that causes automatic splitting of the fuel nuclei has been established
Answer» E.
8.

The risk of radioactive hazard is greatest in the turbine with following reactor%!

A. Pressurised water
B. Boiling water
C. Gas cooled
D. Liquid metal cooled
Answer» C. Gas cooled
9.

The function of control rods in nuclear plants is to%!

A. Control temperature
B. Control radioactive pollution
C. Control absorption of neutron
D. Control fuel consumption
Answer» D. Control fuel consumption
10.

Enriched uranium is one in which%!

A. Percentage of U₂₃₅ has been artificially increased
B. Percentage of U has been artificially increased
C. Percentage of U₂₃₄ has been artificially increased
D. Extra energy is pumped from outside
Answer» B. Percentage of U has been artificially increased
11.

The energy required to be applied to a radioactive nucleus for the emission of a neutron is%!

A. 1 MeV
B. 2.4 MeV
C. 4.3 MeV
D. 7.8 MeV
Answer» E.
12.

Which of the following statement is correct regarding the features of a Breeder reactor?%!

A. It produces more fuel than it consumes
B. It requires highly enriched fuel
C. It requires liquid sodium metal as moderator
D. All of the above
Answer» E.
13.

The efficiency of a nuclear power plant in comparison to conventional and nuclear consideration is%!

A. Higher cost of nuclear fuel
B. High initial cost
C. High heat rejection in condenser
D. Lower temperature and pressure conditions
Answer» E.
14.

Which of the following is the heaviest?%!

A. Neutron
B. Proton
C. Atom
D. Electron
Answer» D. Electron
15.

One gram of uranium will produce energy equivalent to approximately%!

A. 1 tonne of high grade coal
B. 4.5 tonnes of high grade coal
C. 10 tonnes of high grade coal
D. 100 tonnes of high grade coal
Answer» C. 10 tonnes of high grade coal
16.

Effective moderators are those materials which contain%!

A. Light weight atoms
B. Heavy weight atoms
C. Critical atoms
D. Zero weight atoms
Answer» B. Heavy weight atoms
17.

The control rods in the control system of nuclear reactors are used to%!

A. Absorb excess neutrons
B. Control fuel consumption
C. Control temperature
D. All of these
Answer» B. Control fuel consumption
18.

Pick up the wrong statement%!

A. In a heterogeneous or solid fuel reactor, the fuel is mixed in a regular pattern within moderator
B. Slow or thermal neutrons have energy of the order or 0.025 eV
C. Fast neutrons have energies above 1000 eV
D. Fast reactor uses moderator
Answer» E.
19.

In order to have constant chain reaction to produce a constant rate of heat output, the value of ratio of the number of neutrons in one generation to the number of neutrons in the immediately preceding generation must be%!

A. Greater than 1.0
B. Less than 1.0
C. Equal to zero
D. Equal to 1.0
Answer» E.
20.

For economical operation of a nuclear plant%!

A. Used fuel should be reprocessed
B. Moderator should be used
C. Coolant should be employed
D. Control rods should be used
Answer» B. Moderator should be used
21.

*$_Which of the following is the heaviest??

A. Neutron
B. Proton
C. Atom
D. Electron
Answer» D. Electron
22.

*$_The efficiency of a nuclear power plant in comparison to conventional and nuclear consideration is?

A. Higher cost of nuclear fuel
B. High initial cost
C. High heat rejection in condenser
D. Lower temperature and pressure conditions
Answer» E.
23.

*$_Pick up the wrong statement?

A. In a heterogeneous or solid fuel reactor, the fuel is mixed in a regular pattern within moderator
B. Slow or thermal neutrons have energy of the order or 0.025 eV
C. Fast neutrons have energies above 1000 eV
D. Fast reactor uses moderator
Answer» E.
24.

*$_The control rods in the control system of nuclear reactors are used to?

A. Absorb excess neutrons
B. Control fuel consumption
C. Control temperature
D. All of these
Answer» B. Control fuel consumption
25.

*$_Effective moderators are those materials which contain?

A. Light weight atoms
B. Heavy weight atoms
C. Critical atoms
D. Zero weight atoms
Answer» B. Heavy weight atoms
26.

*$_One gram of uranium will produce energy equivalent to approximately?

A. 1 tonne of high grade coal
B. 4.5 tonnes of high grade coal
C. 10 tonnes of high grade coal
D. 100 tonnes of high grade coal
Answer» C. 10 tonnes of high grade coal
27.

*$_For economical operation of a nuclear plant?

A. Used fuel should be reprocessed
B. Moderator should be used
C. Coolant should be employed
D. Control rods should be used
Answer» B. Moderator should be used
28.

*$_In order to have constant chain reaction to produce a constant rate of heat output, the value of ratio of the number of neutrons in one generation to the number of neutrons in the immediately preceding generation must be?

A. Greater than 1.0
B. Less than 1.0
C. Equal to zero
D. Equal to 1.0
Answer» E.
29.

*$_The energy required to be applied to a radioactive nucleus for the emission of a neutron is?

A. 1 MeV
B. 2.4 MeV
C. 4.3 MeV
D. 7.8 MeV
Answer» E.
30.

*$_A nuclear unit becoming critical means?

A. It is generating power to rated capacity
B. It is capable of generating much more than rated capacity
C. There is danger of nuclear spread
D. Chain reaction that causes automatic splitting of the fuel nuclei has been established
Answer» E.
31.

*$_The function of control rods in nuclear plants is to?

A. Control temperature
B. Control radioactive pollution
C. Control absorption of neutron
D. Control fuel consumption
Answer» D. Control fuel consumption
32.

*$_Enriched uranium is one in which?

A. Percentage of U₂₃₅ has been artificially increased
B. Percentage of U has been artificially increased
C. Percentage of U₂₃₄ has been artificially increased
D. Extra energy is pumped from outside
Answer» B. Percentage of U has been artificially increased
33.

*$_The risk of radioactive hazard is greatest in the turbine with following reactor?

A. Pressurised water
B. Boiling water
C. Gas cooled
D. Liquid metal cooled
Answer» C. Gas cooled
34.

*$_Hydrogen is preferred as better coolant in comparison to CO‚ÇÇ because former?

A. Is lighter
B. Is inert
C. Has high specific heat
D. Is a good conductor
Answer» D. Is a good conductor
35.

*$_Which of the following statement is correct regarding the features of a Breeder reactor??

A. It produces more fuel than it consumes
B. It requires highly enriched fuel
C. It requires liquid sodium metal as moderator
D. All of the above
Answer» E.
36.

*/*_Ideally the neutron flux in reactor should be?

A. Maximum in centre and zero at side
B. Maximum at side and zero in canter
C. Uniform throughout
D. Zero throughout
Answer» D. Zero throughout
37.

*/*_The presence of reflector in nuclear power plants results in?

A. Increased production of neutrons
B. Complete absorption of neutrons
C. Controlled production of neutrons
D. Decreased leakage of neutrons
Answer» E.
38.

*/*_In triggering fission, the following types of neutrons are desirable?

A. Fast moving
B. Slow moving
C. Critical neutrons
D. Neutrons at rest
Answer» C. Critical neutrons
39.

*/*_The process by which a heavy nucleus is spitted into two light nuclei is known as?

A. Splitting
B. Fission
C. Fusion
D. Disintegration
Answer» C. Fusion
40.

*/*_Atomic number of an element in the periodic table represents the numbers of?

A. Protons in the nucleus
B. Electrons in the nucleus
C. Neutrons in the nucleus
D. Electrons in the atom
Answer» B. Electrons in the nucleus
41.

*/*_The nuclear radiators produced in a reactor which must be shielded are?

A. Electrons
B. α, β and γ rays
C. Neutron and gamma rays
D. None of these
Answer» D. None of these
42.

*/*_The main interest of shielding in nuclear reactor is protection against?

A. X-rays
B. Infrared rays
C. Neutrons and gamma rays
D. Electrons
Answer» E.
43.

*/*_Breeder reactor has a conversion ratio of?

A. Unity
B. More than unity
C. Less than unity
D. Zero
Answer» C. Less than unity
44.

*/*_The size of the reactor is said to be critical when?

A. Chain reaction can be initiated
B. It becomes uncontrollable
C. It explodes
D. It produces no power
Answer» B. It becomes uncontrollable
45.

*/*_A fission chain reaction in uranium can be developed?

A. By increasing the contents of U₂₃₅
B. By slowing down fast neutrons so that U₂₃₅ fission continues by slow neutron
C. Both (A) and (B)
D. None of these
Answer» D. None of these
46.

*/*_The material most commonly used for shielding is?

A. Carbon
B. Lead
C. Concrete
D. All of these
Answer» D. All of these
47.

*/*_U238 will undergo fission by?

A. High energy (fast) neutrons alone
B. Low energy (slow) neutrons alone
C. Either fast or slow neutrons
D. Medium energy neutrons
Answer» B. Low energy (slow) neutrons alone
48.

*/*_Superheated steam is generated in following reactor?

A. Boiling water
B. Gas cooled
C. Pressurised water
D. All of the above
Answer» C. Pressurised water
49.

*/*_Natural uranium is made up of?

A. 99.282% U‚Äö√á√á‚Äö√á√â‚Äö√á√ , 0.712% U‚Äö√á√á‚Äö√á√â‚Äö√á√ñ, 0.006% U‚Äö√á√á‚Äö√á√â‚Äö√á√ë
B. 99.282% U‚Äö√á√á‚Äö√á√â‚Äö√á√ñ, 0.712% U‚Äö√á√á‚Äö√á√â‚Äö√á√ , 0.06%' U‚Äö√á√á‚Äö√á√â‚Äö√á√ë
C. 99.282% U‚Äö√á√á‚Äö√á√â‚Äö√á√ë, 0.712% U‚Äö√á√á‚Äö√á√â‚Äö√á√ , 0.006% U‚Äö√á√á‚Äö√á√â‚Äö√á√ñ
D. 99.282% U‚Äö√á√á‚Äö√á√â‚Äö√á√ñ, 0.712% U‚Äö√á√á‚Äö√á√â‚Äö√á√ë, 0.006% U‚Äö√á√á‚Äö√á√â‚Äö√á√
Answer» B. 99.282% U‚Äö√á√á‚Äö√á√â‚Äö√á√ñ, 0.712% U‚Äö√á√á‚Äö√á√â‚Äö√á√ , 0.06%' U‚Äö√á√á‚Äö√á√â‚Äö√á√ë
50.

*/*_Which is not identical for an atom and an isotope??

A. Mass number
B. Atomic number
C. Chemical properties
D. Position in periodic table
Answer» B. Atomic number