MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 12 Mcqs, each offering curated multiple-choice questions to sharpen your Manufacturing Engineering knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
Which of the following milling operation will require lower force of cut? |
| A. | Up milling |
| B. | Climb milling |
| C. | Down milling |
| D. | None of the mentioned |
| Answer» D. None of the mentioned | |
| 2. |
In which of the following methods of milling there would be less radial pressure on the arbor? |
| A. | Up milling |
| B. | Conventional milling |
| C. | Down milling |
| D. | None of the mentioned |
| Answer» D. None of the mentioned | |
| 3. |
In which of the following milling method chip thickness is nearly zero at the end of cut? |
| A. | Up milling |
| B. | Conventional milling |
| C. | Down milling |
| D. | None of the mentioned |
| Answer» C. Down milling | |
| 4. |
In which of the following milling method chip thickness decrease gradually? |
| A. | Up milling |
| B. | Conventional milling |
| C. | Down milling |
| D. | None of the mentioned |
| Answer» D. None of the mentioned | |
| 5. |
IN_WHICH_OF_THE_FOLLOWING_METHODS_OF_MILLING_THERE_WOULD_BE_LESS_RADIAL_PRESSURE_ON_THE_ARBOR??$ |
| A. | Up milling |
| B. | Conventional milling |
| C. | Down milling |
| D. | None of the mentioned |
| Answer» D. None of the mentioned | |
| 6. |
Which_of_the_following_milling_operation_will_require_lower_force_of_cut?$ |
| A. | Up milling |
| B. | Climb milling |
| C. | Down milling |
| D. | None of the mentioned |
| Answer» D. None of the mentioned | |
| 7. |
In which of the following methods work piece will have a tendency to be pulled up? |
| A. | Up milling |
| B. | Climb milling |
| C. | Down milling |
| D. | None of the mentioned |
| Answer» B. Climb milling | |
| 8. |
Which of the following will result in best surface finish of job? |
| A. | Up milling |
| B. | Conventional milling |
| C. | Down milling |
| D. | None of the mentioned |
| Answer» D. None of the mentioned | |
| 9. |
In which of the following milling method chip thickness is maximum at the end of cut? |
| A. | Up milling |
| B. | Climb milling |
| C. | Down milling |
| D. | None of the mentioned |
| Answer» B. Climb milling | |
| 10. |
In which of the following milling method chip thickness is nearly zero at the start of cut? |
| A. | Up milling |
| B. | Climb milling |
| C. | Down milling |
| D. | None of the mentioned |
| Answer» B. Climb milling | |
| 11. |
In which of the following milling method chip thickness increase gradually? |
| A. | Up milling |
| B. | Climb milling |
| C. | Down milling |
| D. | None of the mentioned |
| Answer» B. Climb milling | |
| 12. |
In which of the following milling method cutters rotate in direction opposite to that in which work is fed? |
| A. | Up milling |
| B. | Climb milling |
| C. | Down milling |
| D. | None of the mentioned |
| Answer» B. Climb milling | |