MCQOPTIONS
Saved Bookmarks
MCQOPTIONS
This section includes 10 Mcqs, each offering curated multiple-choice questions to sharpen your Manufacturing Engineering knowledge and support exam preparation. Choose a topic below to get started.
| 1. |
In manufacturing of hole and shaft, maximum shaft diameter was 49.88 mm and minimum hole diameter was found to be 49.94 mm. It is a |
| A. | Clearance fit |
| B. | Interference fit |
| C. | Transition fit |
| D. | None of the mentioned |
| Answer» B. Interference fit | |
| 2. |
For manufacturing of a certain amount of hole, maximum hole size was found to be 50.14 mm and minimum hole size was found to be 49.98. Tolerance in mm will be |
| A. | 0.12 |
| B. | 0.13 |
| C. | 0.16 |
| D. | 0.20 |
| Answer» D. 0.20 | |
| 3. |
Value of minimum interference is given by |
| A. | Size of smallest hole – size of biggest hole |
| B. | Size of smallest shaft + size of biggest hole |
| C. | Size of smallest shaft – size of biggest hole |
| D. | None of the mentioned |
| Answer» D. None of the mentioned | |
| 4. |
Value of maximum Interference is given by |
| A. | Size of smallest hole – size of biggest shaft |
| B. | Largest of shaft size hole – smallest hole size |
| C. | Size of smallest shaft – size of biggest shaft |
| D. | None of the mentioned |
| Answer» C. Size of smallest shaft – size of biggest shaft | |
| 5. |
When size of smallest shaft is more than size of biggest hole then it is |
| A. | Clearance fit |
| B. | Interference fit |
| C. | Transition fit |
| D. | None of the mentioned |
| Answer» C. Transition fit | |
| 6. |
Value of maximum clearance is given by |
| A. | Size of smallest hole – size of biggest hole |
| B. | Size of smallest shaft + size of biggest hole |
| C. | Size of smallest shaft – size of biggest shaft |
| D. | None of the mentioned |
| Answer» C. Size of smallest shaft – size of biggest shaft | |
| 7. |
Value of minimum clearance is given by |
| A. | Size of smallest hole – size of biggest shaft |
| B. | Size of smallest hole + size of biggest hole |
| C. | Size of smallest shaft – size of biggest shaft |
| D. | None of the mentioned |
| Answer» B. Size of smallest hole + size of biggest hole | |
| 8. |
When size of the smallest hole is more than size of biggest shaft then it is |
| A. | Clearance fit |
| B. | Interference fit |
| C. | Transition fit |
| D. | None of the mentioned |
| Answer» B. Interference fit | |
| 9. |
Nearest deviation between hole and shaft from the basic value is known as |
| A. | Tolerance |
| B. | Fundamental deviation |
| C. | Clearance |
| D. | Interference |
| Answer» C. Clearance | |
| 10. |
Maximum deviation in size of shaft or hole is known as |
| A. | Tolerance |
| B. | Fundamental deviation |
| C. | Clearance |
| D. | Interference |
| Answer» B. Fundamental deviation | |