Explore topic-wise MCQs in Chemical Engineering.

This section includes 288 Mcqs, each offering curated multiple-choice questions to sharpen your Chemical Engineering knowledge and support exam preparation. Choose a topic below to get started.

1.

Catalyst used in the manufacture of NH by Haber's process is finely divided

A. nickel
B. iron
C. vanadium pentoxide
D. alumina
Answer» C. vanadium pentoxide
2.

Fertiliser plants get their N requirements

A. by fractionation of liquified air.
B. by dissociating oxides of nitrogen.
C. from coal gas (coke oven gas).
D. from producer gas.
Answer» B. by dissociating oxides of nitrogen.
3.

(CH C H) PO is the chemical formula of

A. triple superphosphate
B. tricresyl phosphate
C. flourapatite
D. superphosphate
Answer» C. flourapatite
4.

CO present in reformed gas (obtained by steam reforming of naphtha) is removed by absorbing in

A. mono-ethanolamine (MEA)
B. slaked lime
C. ammoniacal liquor
D. Methyl-Ethyl Ketone (MEK)
Answer» B. slaked lime
5.

PO content in triple superphosphate is about __________ percent.

A. 42-50
B. 15-20
C. 85-90
D. 70-75
Answer» B. 15-20
6.

HPO is the chemical formula of __________ phosphoric acid.

A. pyro
B. ortho
C. meta
D. none of these
Answer» C. meta
7.

Use of catalyst is a must in the ammonia manufacture, because the reaction is reversible as well as the heat of dissociation of N & H is high. The presence of promoter along with the catalyst helps in __________ of the catalyst.

A. stabilisation
B. increasing the effectiveness
C. improving the strength & heat resistance
D. all a, b & c
Answer» E.
8.

A fertiliser contains 82% N. It could be

A. urea
B. liquid NH
C. ammonium nitrate
D. none of these
Answer» C. ammonium nitrate
9.

A nitrogenous fertiliser contains 20% N. It could be

A. ammonium nitrate.
B. calcium ammonium nitrate (CAN).
C. urea.
D. ammonium chloride.
Answer» C. urea.
10.

HPO is the chemical formula of __________ phosphoric acid.

A. pyro
B. ortho
C. meta
D. none of these
Answer» D. none of these
11.

Reaction of phosphate rock with 98% HSO produces

A. orthophosphoric acid
B. superphosphate
C. white phosphorous
D. none of these
Answer» B. superphosphate
12.

Multistage operation (as in the case of catalytic oxidation of SO) is not carried out for NH synthesis, because of

A. comparatively higher pressure drop.
B. high cost of the high pressure vessel used for the reactor.
C. higher pumping cost.
D. chances of entrainment and disturbance of catalyst bed.
Answer» C. higher pumping cost.
13.

HPO is the chemical formula of __________ phosphoric acid.

A. pyro
B. ortho
C. meta
D. none of these
Answer» B. ortho
14.

CaH(PO) is the chemical formula of

A. superphosphate
B. triple superphosphate
C. calcium phosphate
D. meta phosphoric acid
Answer» C. calcium phosphate
15.

Formation of ammonium carbamate by reaction of NH with CO is a/an __________ reaction.

A. catalytic
B. exothermic
C. endothermic
D. reversible
Answer» C. endothermic
16.

A potassic fertiliser contains 50% KO. It could be

A. potassium sulphate.
B. potassium chloride.
C. a mixture of NaCl+ KCl.
D. none of these.
Answer» B. potassium chloride.
17.

A phosphatic fertiliser contains 16% PO. It could be

A. dicalcium phosphate
B. superphosphate
C. triple superphosphate
D. none of these
Answer» C. triple superphosphate
18.

I argest capacity nitrogenous fertiliser plants (2700 tons of NH per day) (2 Nos) in India are located at

A. Thal-Vaishet (under RCF in Maharashtra) and Hazira (under IFFCO in Gujarat).
B. Talchar (Orissa) and Ramagundam (A.P.) both under FCI.
C. Korba (M.P.) and Talchar (Orissa) both under FCI.
D. Haldia (W.B) and Namrup (Assam) both under HFC.
Answer» B. Talchar (Orissa) and Ramagundam (A.P.) both under FCI.
19.

Optimum reaction temperature in steam reforming of naphtha is __________ °C.

A. 700 - 1000
B. 300 - 450
C. 1500-1700
D. 100-200
Answer» B. 300 - 450
20.

Conversion achieved in HNO synthesis with the use of platinum catalyst is about 95-97%. The rate of formation of nitrogen dioxide from the oxidation of nitric acid is favoured by

A. decreasing the pressure.
B. decreasing the temperature.
C. increasing the temperature.
D. none of these.
Answer» D. none of these.
21.

In ammonia synthesis (N + 3H = 2NH), there is a decrease in total volume, hence to get high equilibrium conversion, the reaction should be carried out at

A. low pressure.
B. high pressure.
C. very high temperature.
D. atmospheric pressure; as the pressure has no effect on conversion.
Answer» C. very high temperature.
22.

In the manufacture of H PO (ortho), ; strong H SO leaching wet process as compared to electric furnace process

A. uses lower grade phosphate rock.
B. requires lower capital investment in the plant.
C. produces lower purity acid.
D. is very costly.
Answer» D. is very costly.
23.

During nitric acid manufacture, catalytic oxidation of ammonia at 800°C in presence of platinum catalyst produces nitrogen oxide. Conversion of NH to NO is about __________ percent.

A. 38
B. 68
C. 82
D. 98
Answer» E.
24.

Out of the following, N content is minimum in

A. urea
B. ammonium nitrate
C. ammonium sulphate
D. ammonium chloride
Answer» D. ammonium chloride
25.

Which of the following solvents is used for the extraction of HPO from CaCl solution during manufacture of ortho-phosphoric acid by wet process employing hydrochloric acid leaching?

A. Iso propyl alcohol
B. Butyl alcohol
C. Toluene
D. Hexane
Answer» C. Toluene
26.

Triple superphosphate which contains about 46% PO is produced by the reaction of phosphate rock with ortho phosphoric acid of____percent concentration.

A. 25-28
B. 52-54
C. 75-80
D. > 98
Answer» C. 75-80
27.

PO content in superphosphate is about __________ percent.

A. 30-35
B. 15-20
C. 65-70
D. 85-90
Answer» C. 65-70
28.

Though kinetics of ammonia synthesis dictates the use of low temperature for high equilibrium conversion, yet it is kept moderately high (550°C), because at low temperature

A. rate of reaction is very low.
B. very high pressure is required resulting in costly pressure vessel.
C. space velocity of gas is very low resulting in decreased conversion.
D. none of these
Answer» B. very high pressure is required resulting in costly pressure vessel.
29.

__________ catalyst is used in the production of urea from CO and NH.

A. Vanadium pentoxide
B. No
C. Alumina
D. Nickel
Answer» C. Alumina
30.

PO percentage in the phosphoric acid produced by wet process is about

A. 10
B. 30
C. 50
D. 70
Answer» C. 50
31.

In the manufacture of orthophosphoric acid by strong H2SO4 leaching wet process, keeping the reactor temperature above 100°C, results in the formation of undesriable

A. CaSO4 .H2O and CaSO4 crystals
B. pyrophosphoric acid
C. metaphosphoric acid
D. all (a), (b) and (c).
Answer» B. pyrophosphoric acid
32.

During nitric acid manufacture, catalytic oxidation of ammonia at 800°C in presence of platinum catalyst produces nitrogen oxide. Conversion of NH3 to NO is about __________ percent.

A. 38
B. 68
C. 82
D. 98
Answer» E.
33.

Which of the following set of conditions is favourable for the maximum yield of ammonia by Haber's process?

A. igh pressure, low reactants concentration, high temperature
B. igh pressure, low reactants concentration, low temperature
C. igh pressure, high reactants concentration, low temperature
D. ow pressure, high reactants concentration, low temperature
Answer» D. ow pressure, high reactants concentration, low temperature
34.

Which of the following fertilisers is required for the development of fibrous materials of the plants and of the sugar of vegetable & fruits?

A. itrogenous fertilisers
B. hosphatic fertilisers
C. otassic fertiliser
D. one of these
Answer» D. one of these
35.

Which of the following is the costliest method for commercial production of hydrogen for ammonia synthesis?

A. ? separation from coke oven gas
B. team reforming of naphtha
C. racking of natural gas
D. lectrolysis of water
Answer» E.
36.

Which of the following is the costliest source of hydrogen needed for ammonia manufacture under Indian condition?

A. lectrolysis of water
B. ryogenic removal of H₂ from coke oven gas
C. team reforming of naphtha
D. atural gas cracking
Answer» B. ryogenic removal of H₂ from coke oven gas
37.

Which one of the following is used as a nitrogenous fertiliser, as a weed killer in the onion fields and for correcting acidic soils?

A. rea
B. AN
C. mmonium sulphate
D. alcium cyanamide
Answer» E.
38.

Though kinetics of ammonia synthesis dictates the use of low temperature for high equilibrium conversion, yet it is kept moderately high (550°C), because at low temperature

A. Rate of reaction is very low
B. Very high pressure is required resulting in costly pressure vessel
C. Space velocity of gas is very low resulting in decreased conversion
D. None of these
Answer» B. Very high pressure is required resulting in costly pressure vessel
39.

Which is a catalyst promoter used in catalytic ammonia synthesis reaction?

A. Al₂O₃
B. Cr₂O₃
C. K₂O
D. MnO
Answer» D. MnO
40.

__________ catalyst is used in the production of urea from CO₂ and NH₃.

A. Vanadium pentoxide
B. No
C. Alumina
D. Nickel
Answer» C. Alumina
41.

Fertiliser plants get their N₂ requirements

A. By fractionation of liquified air
B. By dissociating oxides of nitrogen
C. From coal gas (coke oven gas)
D. From producer gas
Answer» B. By dissociating oxides of nitrogen
42.

CaH₄(PO₄)₂ is the chemical formula of

A. Superphosphate
B. Triple superphosphate
C. Calcium phosphate
D. Meta phosphoric acid
Answer» C. Calcium phosphate
43.

I argest capacity nitrogenous fertiliser plants (2700 tons of NH₃ per day) (2 Nos) in India are located at

A. Thal-Vaishet (under RCF in Maharashtra) and Hazira (under IFFCO in Gujarat)
B. Talchar (Orissa) and Ramagundam (A.P.) both under FCI
C. Korba (M.P.) and Talchar (Orissa) both under FCI
D. Haldia (W.B) and Namrup (Assam) both under HFC
Answer» B. Talchar (Orissa) and Ramagundam (A.P.) both under FCI
44.

Formation of ammonium carbamate by reaction of NH₃ with CO₂ is a/an __________ reaction.

A. Catalytic
B. Exothermic
C. Endothermic
D. Reversible
Answer» C. Endothermic
45.

Conversion of yellow phosphorous to red phosphorous is done by heating it in covered retorts at __________ °C in absence of air.

A. 50-80
B. 250-400
C. 1000-1200
D. 800-900
Answer» C. 1000-1200
46.

Out of the following, N₂ content is minimum in

A. Urea
B. Ammonium nitrate
C. Ammonium sulphate
D. Ammonium chloride
Answer» D. Ammonium chloride
47.

Which is the most suitable fertiliser for paddy?

A. CAN
B. Ammonium sulphate
C. Ammonium nitrate
D. Superphosphate
Answer» C. Ammonium nitrate
48.

Heating of orthophosphoric acid to 250°C produces

A. Metaphosphoric acid
B. Pyrophosphoric acid
C. No change in it
D. None of these
Answer» C. No change in it
49.

Fusion zone in the electric furnace used for reduction of phosphate rock to elemental phosphorous is maintained at __________ °C.

A. 250-300
B. 500-750
C. 950-1050
D. 1400-1450
Answer» E.
50.

Naphtha in a fertiliser plant is used as a source of

A. Fuel
B. H₂
C. N₂
D. O₂
Answer» C. N₂