

MCQOPTIONS
Saved Bookmarks
This section includes 1331 Mcqs, each offering curated multiple-choice questions to sharpen your Chemical Engineering knowledge and support exam preparation. Choose a topic below to get started.
1. |
Oxidation of SO to SO is favoured by |
A. | low temperature and low pressure. |
B. | low temperature and high pressure. |
C. | high temperature and low pressure. |
D. | high temperature and high pressure. |
Answer» C. high temperature and low pressure. | |
2. |
The gasification reaction represented by, C + HO = CO + H, is a/an __________ reaction. |
A. | exothermic |
B. | endothermic |
C. | catalytic |
D. | autocatalytic |
Answer» C. catalytic | |
3. |
The combustion reaction, C + O = CO, is |
A. | exothermic |
B. | endothermic |
C. | autocatalytic |
D. | none of these |
Answer» B. endothermic | |
4. |
During the manufacture of sulphuric acid, the temperature of molten sulphur is not increased beyond 160°C, as |
A. | it is very corrosive at elevated temperature. |
B. | its viscosity is not reduced on further heating (hence pressure drop on pumping it, cannot be further reduced). |
C. | it decomposes on further increasing the temperature. |
D. | none of these. |
Answer» C. it decomposes on further increasing the temperature. | |
5. |
NaCO is called |
A. | washing soda |
B. | soda ash |
C. | plaster of paris |
D. | calcite |
Answer» C. plaster of paris | |
6. |
The temperature in the calcium carbide furnace is __________ °C. |
A. | 200-300 |
B. | 700-850 |
C. | 2000-2200 |
D. | 4000-4500 |
Answer» D. 4000-4500 | |
7. |
Argon is the third largest constituent of air (followed by N & O). Its percentage by volume in air is |
A. | 0.14 |
B. | 0.34 |
C. | 0.94 |
D. | 1.4 |
Answer» D. 1.4 | |
8. |
In contact process, SO is absorbed in 97% HSO and not in water, because |
A. | SO |
B. | gas is sparingly soluble in water. |
C. | water forms an acid mist, which is difficult to absorb. |
D. | the purity of acid is affected. |
E. | scale formation in the absorber is to be avoided. |
Answer» C. water forms an acid mist, which is difficult to absorb. | |
9. |
Oxygen is separated by distillation from air after its liquefaction. The boiling point of oxygen is about __________ °C. |
A. | -83 |
B. | -183 |
C. | -196 |
D. | -218 |
Answer» C. -196 | |
10. |
Which of the following contains least amount of N ? |
A. | Coke oven gas |
B. | Blast furnace gas |
C. | Producer gas |
D. | Water gas (blue gas). |
Answer» B. Blast furnace gas | |
11. |
Purity of oxygen used for blowing in steel making L.D. converter is 99.5%. The boiling point of oxygen is about __________ °C. |
A. | -53 |
B. | -103 |
C. | -183 |
D. | -196 |
Answer» D. -196 | |
12. |
Mercury electrolytic cell produces 50-70% NaOH solution. Its operating temperature is __________ °C. |
A. | 25 |
B. | 60-70 |
C. | 150-200 |
D. | 250-300 |
Answer» C. 150-200 | |
13. |
Exothermic condensation reaction of monochlorobenzene with chloral in presence of 20% oleum as catalyst produces DDT. The reaction temperature is maintained at __________ °C. |
A. | 15-30 |
B. | 90-100 |
C. | 250-300 |
D. | <0 |
Answer» B. 90-100 | |
14. |
Sand and __________ is fused at 1300°C, to produce sodium silicate. |
A. | limestone |
B. | soda ash |
C. | coke |
D. | sodium sulphate |
Answer» C. coke | |
15. |
At a given temperature, the equilibrium yield of SO obtained from the oxidation of SO is proportional to (where, = pressure of the system ) |
A. | 1/ |
Answer» C. | |
16. |
Flash point of most vegetable oils is about __________ °C. |
A. | 50 |
B. | 100 |
C. | 200 |
D. | 300 |
Answer» D. 300 | |
17. |
Polymerisation product of CF (carbon tetraflouride) is called P.T.F.E (poly chloro tetra flouro ethylene). It is also called |
A. | polyurethane |
B. | silicone |
C. | teflon |
D. | epoxy resin |
Answer» D. epoxy resin | |
18. |
Very dilute solutions are generally used in fermentation reactions for which the optimum temperature range is __________ °C. |
A. | -5 to 0 |
B. | 5 to 10 |
C. | 30 to 50 |
D. | 75 to 80 |
Answer» D. 75 to 80 | |
19. |
Conversion of CO to CO by steam in presence of a catalyst is called |
A. | steam reforming. |
B. | shift conversion. |
C. | steam gasification. |
D. | none of these. |
Answer» C. steam gasification. | |
20. |
Commercial scale production of hydrogen from iron-steam reaction represented by, 3Fe + 3HO = FeO4 + 4H, is not practised, as it is |
A. | a slow reaction. |
B. | a discontinuous reaction (requiring regeneration of iron by water gas intermittently). |
C. | still in development stage (by employing fluidised bed technique). |
D. | all (a), (b) and (c). |
Answer» E. | |
21. |
The purpose of adding NaCO to water of low alkalinity is to |
A. | permit the use of alum as a coagulant. |
B. | increase the softening capacity of zeolite. |
C. | facilitate easy regeneration of zeolite. |
D. | all (a), (b) and (c). |
Answer» B. increase the softening capacity of zeolite. | |
22. |
Ca(OH) is called |
A. | quicklime |
B. | slaked lime |
C. | limestone |
D. | gypsum |
Answer» C. limestone | |
23. |
SO is bubbled through hot sugar cane juice to |
A. | act as an acidifying agent. |
B. | increase its concentration. |
C. | increase the amount of molasses. |
D. | increase the crystal size. |
Answer» B. increase its concentration. | |
24. |
Heating of __________ to 120°C, produces plaster of paris. |
A. | blue vitriol |
B. | gypsum |
C. | calcium silicate |
D. | calcium sulphate |
Answer» C. calcium silicate | |
25. |
Absorption of SO in 97% HSO is |
A. | exothermic |
B. | endothermic |
C. | not possible |
D. | none of these |
Answer» B. endothermic | |
26. |
Which of the following processes does not produce Cl as a co-product during the manufacture of caustic soda ? |
A. | Diaphragm electrolytic cell process |
B. | Mercury electrolytic cell process |
C. | Lime-soda process |
D. | None of these |
Answer» D. None of these | |
27. |
Carbon tetrachloride (CCl) is the starting raw material for the manufacture of |
A. | trichloroethylene |
B. | perchloroethylene |
C. | parathion |
D. | methanol |
Answer» C. parathion | |
28. |
The compressive strength of cement should not be less than about 110Kg/cm after three days & not less than 170Kg/cm after seven days. The fineness of an ordinary cement as determined by turbidimetric method should be about __________ cm/gm. |
A. | 800 |
B. | 1600 |
C. | 4000 |
D. | 8500 |
Answer» C. 4000 | |
29. |
Dry ice (solidified CO) is used for the |
A. | storage & shipment of frozen foods and ice-creams. |
B. | liquefaction of permanent gases. |
C. | liquefaction of natural gas. |
D. | none of these. |
Answer» B. liquefaction of permanent gases. | |
30. |
Conversion of SO to SO in Monsanto 4-pass converter is about __________ percent. |
A. | 80 |
B. | 90 |
C. | 98 |
D. | 100 |
Answer» D. 100 | |
31. |
Temperature during hydrogenation of oil should not be more than 200°C, otherwise it will result in |
A. | pyrolysis of oil. |
B. | sintering of porous catalyst. |
C. | hydrogen embrittlement. |
D. | all (a), (b) and (c). |
Answer» E. | |
32. |
Fermentator temperature during production of alcohol from molasses is around __________ °C. |
A. | 5 |
B. | 30 |
C. | 150 |
D. | 300 |
Answer» C. 150 | |
33. |
Alum [Al(SO)] is used as a coagulant in water treatment to remove |
A. | colour |
B. | turbidity |
C. | bacteria |
D. | all (a), (b) and (c) |
Answer» E. | |
34. |
90% of the caprolactum is converted to nylon-6 on its condensation polymerisation in the reactor maintained at __________ °C. |
A. | <0 |
B. | 10-30 |
C. | 250-280 |
D. | 500-600 |
Answer» C. 250-280 | |
35. |
Hydrazine (NH) is used mainly as a/an |
A. | explosive |
B. | rocket fuel |
C. | detergents additive |
D. | none of these |
Answer» C. detergents additive | |
36. |
CO & H are the constituents of |
A. | producer gas |
B. | water gas |
C. | coke oven gas |
D. | all (a), (b) and (c) |
Answer» E. | |
37. |
Presence of HS in raw water (to be chlorinated) results in the |
A. | reduced softening capacity of zeolite. |
B. | increased dosage of chlorine to provide a disinfecting residual in the water. |
C. | easy removal of its hardness. |
D. | none of these. |
Answer» C. easy removal of its hardness. | |
38. |
NaCO.10HO is called |
A. | washing soda |
B. | soda ash |
C. | slaked lime |
D. | quicklime |
Answer» B. soda ash | |
39. |
CaSO .HO is known as |
A. | blue vitriol |
B. | plaster of Paris |
C. | gypsum |
D. | zeolite |
Answer» C. gypsum | |
40. |
Which of the following sugars is the sweetest ? |
A. | Glucose |
B. | Fructose |
C. | Sucrose |
D. | Lactose |
Answer» C. Sucrose | |
41. |
Which of the following, when pyrolysed, produces Perchloroethylene ? |
A. | Ethylene dichloride |
B. | Chlorobenzene |
C. | Carbon tetrachloride |
D. | Chlorinated paraffin |
Answer» D. Chlorinated paraffin | |
42. |
White phosphorous is stored under water, because __________________? |
A. | It does not react with water |
B. | It is poisonous |
C. | Its kindling temperature in dry air is very low |
D. | It is unstable |
Answer» D. It is unstable | |
43. |
Widely used method for the conditioning of boiler feed water is the ___________________? |
A. | Cold lime process |
B. | Coagulation |
C. | Hot-lime soda process |
D. | Sequestration |
Answer» D. Sequestration | |
44. |
With increase in temperature, the equilibrium constant at constant pressure (Kp) for oxidation of sulphur dioxide________________? |
A. | Increases |
B. | Increases linearly |
C. | Decreases |
D. | Decreases linearly |
Answer» D. Decreases linearly | |
45. |
Wood charcoal is used for decolouration of sugar, because it _______________ the coloured materials? |
A. | Adsorbs |
B. | Oxidises |
C. | Reduces |
D. | Converts |
Answer» B. Oxidises | |
46. |
Yeast is used in the manufacture of ____________________? |
A. | Penicillin |
B. | Antibiotics |
C. | Wine |
D. | Pasteurised milk |
Answer» D. Pasteurised milk | |
47. |
Yellow glycerine is made into white, using____________________? |
A. | Activated carbon |
B. | Diatomaceous earth |
C. | Bauxite |
D. | Bentonite |
Answer» B. Diatomaceous earth | |
48. |
Yellow phosphorus is transported under____________________? |
A. | Air |
B. | Water |
C. | Nitrogen |
D. | Helium |
Answer» C. Nitrogen | |
49. |
Zeigler process__________________? |
A. | Produces high density polyethylene |
B. | Produces low density polyethylene |
C. | Uses no catalyst |
D. | Employs very high pressure |
Answer» B. Produces low density polyethylene | |
50. |
Zeolite is a/an___________________? |
A. | Naturally occuring clay which is capable of exchanging cations |
B. | Abrasive material |
C. | Catalyst used in shift conversion |
D. | None of these |
Answer» B. Abrasive material | |