Explore topic-wise MCQs in Civil Engineering.

This section includes 238 Mcqs, each offering curated multiple-choice questions to sharpen your Civil Engineering knowledge and support exam preparation. Choose a topic below to get started.

51.

The most common cause of acidity in water is_______________?

A. carbon dioxide
B. oxygen
C. hydrogen
D. nitrogen
Answer» B. oxygen
52.

The minimum dissolved oxygen which should always be present in water in order to save the aquatic life is______________?

A. 1 ppm
B. 4 ppm
C. 10 ppm
D. 40 ppm
Answer» C. 10 ppm
53.

The minimum and maximum diameters of sewers shall preferably be_________________?

A. 15 cm and 100 cm
B. 15 cm and 300 cm
C. 30 cm and 450 cm
D. 60 cm and 300cm
Answer» C. 30 cm and 450 cm
54.

The method of analysis of distribution system in which the domestic supply is neglected and fire demand is considered is________________?

A. circle method
B. equivalent pipe method
C. electrical analysis method
D. Hardy cross method
Answer» B. equivalent pipe method
55.

The means of access for inspection and cleaning of sewer line is known as_______________?

A. inlet
B. manhole
C. drop manhole
D. catch basin
Answer» C. drop manhole
56.

The maximum permissible limit for flouride in drinking water is______________?

A. 0.1 mg/litre
B. 1.5 mg/litre
C. 5 mg/litre
D. 10 mg/litre
Answer» C. 5 mg/litre
57.

The maximum efficiency of BOD removal is achieved in______________?

A. oxidation pond
B. oxidation ditch
C. aerated lagoons
D. trickling filters
Answer» C. aerated lagoons
58.

The maximum discharge of a tube-well is about_________________?

A. 5 litres/sec
B. 50 litres/sec
C. 500 litres/sec
D. 1000 litres/see
Answer» C. 500 litres/sec
59.

The major disadvantage of lime soda process of water softening is that_________________?

A. it is unsuitable for turbid and acidic water
B. huge amount of precipitate is formed which creates a disposal problem
C. the effluent cannot be reduced to zero hardness
D. it is unsuitable for softening the water of excessive hardness
Answer» C. the effluent cannot be reduced to zero hardness
60.

The main disadvantage of cement concrete sewers is________________?

A. less strength
B. difficulty in construction
C. difficulty in transportation due to heavy weight
D. less life
Answer» D. less life
61.

The main disadvantage of oxidation pond is that________________?

A. large area is required for construction
B. maintenance and operation cost are high
C. BOD removal is very low
D. none of the above
Answer» B. maintenance and operation cost are high
62.

The length of rectangular sedimentation tank should not be more than_______________?

A. B
B. 2B
C. 4B
D. 8B
Answer» D. 8B
63.

The layout of distribution system in which water flows towards the outer periphery is_________________?

A. ring system
B. dead end system
C. radial system
D. grid iron system
Answer» D. grid iron system
64.

The hydraulic mean depth (HMD. for an egg-shaped sewer flowing two-third full is_______________?

A. equal to HMD when flowing full
B. less than HMD when flowing full
C. greater than HMD when flowing full
D. none of the above
Answer» D. none of the above
65.

The hourly variation factor is usually taken as______________?

A. 1.5
B. 1.8
C. 2.0
D. 2.7
Answer» B. 1.8
66.

The gas from sludge digestion tank is mainly composed of __________________?

A. nitrogen
B. carbon dioxide
C. hydrogen sulphide
D. methane
Answer» E.
67.

The effective size of sand particles used in slow sand filters is_______________?

A. 0.25 to 0.35 mm
B. 0.35 to 0.60 mm
C. 0.60 to 1.00 mm
D. 1.00 to 1.80 mm
Answer» B. 0.35 to 0.60 mm
68.

The effect of increasing diameter of sewer on the self cleansing velocity is_____________?

A. to decrease it
B. to increase it
C. fluctuating
D. nil
Answer» C. fluctuating
69.

The distribution mains are designed for________________?

A. maximum daily demand
B. maximum hourly demand
C. average daily demand
D. maximum hourly demand on maxi¬mum day
Answer» E.
70.

The dissolved oxygen level in natural unpolluted waters at normal temperature is found to be of the order of________________?

A. 1 mg/litre
B. 10 mg/litre
C. 100 mg/litre
D. 1000 mg/litre
Answer» C. 100 mg/litre
71.

The disinfection efficiency of chlorine increases by_______________?_x005F_x000D_1) decreasing the time of contact_x005F_x000D_2) decreasing the temperature of water_x005F_x000D_3) increasing the temperature of water_x005F_x000D_The correct answer is ?

A. only (1)
B. both (1) and (2)
C. both (1) and (3)
D. only (3)
Answer» E.
72.

The devices which are installed for drawing water from the sources are called______________?

A. aquifers
B. aquiclude
C. filters
D. intakes
Answer» E.
73.

The detention period in coagulation tanks is usually kept as_______________?

A. 1 to 2 minutes
B. 30 to 45 minutes
C. 2 to 6 hours
D. 2 to 6 days
Answer» D. 2 to 6 days
74.

The detention period for oxidation ponds is usually kept as______________?

A. 4-8 hours
B. 24 hours
C. 10 to 15 days
D. 3 months
Answer» D. 3 months
75.

The detention period and overflow rate respectively for plain sedimentation as compared to sedimentation with coagulation are generally_______________?

A. less and more
B. less and less
C. more and less
D. more and more
Answer» D. more and more
76.

The design discharge for the combined sewer system shall be taken as________________?

A. equal to rainfall
B. rainfall + DWF
C. rainfall + 2 DWF
D. rainfall + 6 DWF
Answer» D. rainfall + 6 DWF
77.

The design discharge for the separate sewer system shall be taken as_____________?

A. equal to dry weather flow (DWF)
B. 2xDWF
C. 3 x DWF
D. 6xDWF
Answer» E.
78.

The depression of water table in a well due to pumping will be maximum_______________?

A. at a distance R from the well
B. close to the well
C. at a distance R/2 from the well
D. none of the above
Answer» C. at a distance R/2 from the well
79.

The correct relation between theoretical oxygen demand (TOD), Biochemical oxygen demand (BOD) and Chemical oxygen demand (COD) is given by_______________?

A. TOD>BOD>COD
B. TOD>COD>BOD
C. BOD>COD>TOD
D. COD>BOD>TOD
Answer» C. BOD>COD>TOD
80.

The chemical most commonly used to increase speed of sedimentation of sewage is_______________?

A. sulphuric acid
B. copper sulphate
C. lime
D. sodium permanganate
Answer» D. sodium permanganate
81.

The characteristics of fresh and septic sewage respectively are____________________?

A. acidic and alkaline
B. alkaline and acidic
C. both acidic
D. both alkaline
Answer» C. both acidic
82.

The amount of residual chlorine left in public water supply for safety against pathogenic bacteria is about______________?

A. 0.01 to 0.05 ppm
B. 0.05 to 0.5 ppm
C. 0.5 to 1.0 ppm
D. 1.0 to 5.0 ppm
Answer» C. 0.5 to 1.0 ppm
83.

The amount of coagulant needed for coagulation of water increases with_______________?_x005F_x000D_1) increase in turbidity of water_x005F_x000D_2) decrease in turbidity of water_x005F_x000D_3) increase in temperature of water_x005F_x000D_4) decrease in temperature of water_x005F_x000D_The correct answer is?

A. (1) and (2)
B. (1)and (4)
C. (2) and (3)
D. (2) and (4)
Answer» C. (2) and (3)
84.

The alum, when added as a coagulant in water_______________?

A. does not require alkalinity in water for flocculation
B. does not affect pH value of water
C. increases pH value of water
D. decreases pH value of water
Answer» E.
85.

Scour valves are provided ______________?

A. at street corners to control the flow of water
B. at every depression and dead ends to drain out the waste water that may collect there
C. at the foot of rising main along the slope to prevent back running of water
D. at every summit of rising mains
Answer» C. at the foot of rising main along the slope to prevent back running of water
86.

Residual chlorine in water is determined by________________?

A. starch iodide method
B. orthotolidine method
C. both (A) and (B)
D. none of the above
Answer» D. none of the above
87.

Period of cleaning of slow sand filters is about________________?

A. 24 – 48 hours
B. 10-12 days
C. 2-3 months
D. 1-2 year
Answer» D. 1-2 year
88.

Percentage of bacterial load that can be removed from water by the process of plain sedimentation is about_______________?

A. 10 to 25
B. 50
C. 75
D. 100
Answer» D. 100
89.

Orthotolidine test is used for determination of________________?

A. dissolved oxygen
B. residual chlorine
C. biochemical oxygen demand
D. dose of coagulant
Answer» C. biochemical oxygen demand
90.

On standard silica scale, the turbidity in drinking water should be limited to_______________?

A. 10 ppm
B. 20 ppm
C. 30 ppm
D. 50 ppm
Answer» B. 20 ppm
91.

Most suitable section of sewer in separate sewage system is________________?

A. rectangular section
B. circular section
C. standard form of egg shaped sewer
D. modified egg shaped section
Answer» C. standard form of egg shaped sewer
92.

Most of the bacteria in sewage are______________?

A. parasitic
B. saprophytic
C. pathogenic
D. anaerobic
Answer» C. pathogenic
93.

Laying of sewers is usually done with the help of________________?

A. a theodolite
B. a compass
C. sight rails and boning rods
D. a plane table
Answer» D. a plane table
94.

In water treatment, rapid gravity filters are adopted to remove_______________?

A. dissolved organic substances
B. dissolved solids and dissolved gases
C. floating solids and dissolved inorganic solids
D. bacteria and colloidal solids
Answer» E.
95.

In lime-soda process________________?

A. only carbonate hardness is removed
B. only non-carbonate hardness is re-moved
C. lime reduces the carbonate hardness and soda-ash removes the non-carbo¬nate hardness
D. lime reduces the non-carbonate hard-ness and soda-ash removes the carbo¬nate hardness
Answer» D. lime reduces the non-carbonate hard-ness and soda-ash removes the carbo¬nate hardness
96.

In facultative stabilization pond, the sewage is treated by________________?

A. aerobic bacteria only
B. algae only
C. dual action of aerobic bacteria and anaerobic bacteria
D. sedimentation
Answer» D. sedimentation
97.

In chlorination, with the rise in temperature of water, death rate of bacteria____________?

A. increases
B. decreases
C. remains unaffected
D. none of the above
Answer» B. decreases
98.

In a BOD test, 1.0 ml of raw sewage was diluted to 100 ml and the dissolved oxygen concentration of diluted sample at the beginning was 6 ppm and it was 4 ppm at the end of 5 day incubation at 20°C. The BOD of raw sewage will be___________?

A. 100 ppm
B. 200 ppm
C. 300 ppm
D. 400 ppm
Answer» C. 300 ppm
99.

If the total hardness of water is greater than its total alkalinity, the carbonate hardness will be equal to________________?

A. total alkalinity
B. total hardness
C. total hardness – total alkalinity
D. non carbonate hardness
Answer» B. total hardness
100.

If the time of concentration is 9 minutes, then the intensity of rainfall according to British Ministry of Health formula will be__________________?

A. 4 mm/hr
B. 10mm/hr
C. 20 mm/hr
D. 40 mm/hr
Answer» E.