Explore topic-wise MCQs in Engineering.

This section includes 1728 Mcqs, each offering curated multiple-choice questions to sharpen your Engineering knowledge and support exam preparation. Choose a topic below to get started.

301.

If C1, a 4.7 F capacitor, and C2, a 3.3 F capacitor are in series with 18 Vdc applied, what is the voltage across C1?

A. 3.3 V
B. 7.4 V
C. 6.6 V
D. 9.4 V
Answer» C. 6.6 V
302.

What is the impedance of a series RC circuit that consists of a 0.22 F capacitor and a 200-ohm resistor connected to a 3 kHz source?

A. 214 ohms
B. 313 ohms
C. 414 ohms
D. 880 ohms
Answer» C. 414 ohms
303.

What is the reactance value for a capacitor installed in a dc circuit?

A. zero
B. moderate
C. infinite
D. cannot tell
Answer» D. cannot tell
304.

In a purely capacitive circuit,

A. current leads voltage by 90
B. voltage leads current by 90
C. current lags voltage by 90
D. current and voltage have a phase relationship of 0
Answer» B. voltage leads current by 90
305.

How long would it take the capacitor in the given circuit to completely discharge if the switch was in position 2?

A. 22 ms
B. 69 ms
C. 345 ms
D. 420 ms
Answer» E.
306.

In a capacitive circuit, current flow is limited to

A. charging periods
B. discharging periods
C. neither charging periods nor discharging periods
D. both charging periods and discharging periods
Answer» E.
307.

What circuit has the following frequency response?

A. bandpass filter
B. high-pass filter
C. low-pass filter
D. integrator
Answer» D. integrator
308.

A capacitor is constructed of two parallel:

A. conductors
B. semiconductors
C. inductors
D. dielectrics
Answer» B. semiconductors
309.

Which of the following determines the capacitance of a capacitor?

A. Plate area, dielectric strength, and plate separation
B. Voltage rating, dielectric constant, and temperature coefficient
C. Temperature coefficient, plate area, and plate separation
D. Plate area, dielectric constant, and plate separation
Answer» E.
310.

Most older types of paper capacitors have been replaced by which type of construction?

A. electrolytic
B. plastic film
C. oxide casing
D. waxed paper
Answer» C. oxide casing
311.

In an ac circuit, an output capacitor and a resistor are connected in series with an ac signal. What filter action will be the result?

A. bandpass
B. low-pass
C. high-pass
D. band-stop
Answer» C. high-pass
312.

A resistor and an output capacitor form a series circuit with a square wave applied. The circuit is:

A. an integrator
B. a differentiator
C. a multiplier
D. a divider
Answer» B. a differentiator
313.

If an open capacitor is checked with an ohmmeter, the needle will:

A. stay on zero
B. stay on infinity
C. move from zero to infinity
D. move from infinity to zero
Answer» C. move from zero to infinity
314.

What is the circuit's total current?

A. 4.57 mA
B. 9.327 mA
C. 11.570 mA
D. 13.830 mA
Answer» B. 9.327 mA
315.

As a capacitor is being charged, current flowing into the capacitor will:

A. increase
B. decrease
C. remain the same
D. cannot tell
Answer» C. remain the same
316.

What is this circuit?

A. bandpass filter
B. high-pass filter
C. low-pass filter
D. differentiator
Answer» C. low-pass filter
317.

What is the current through XC1 in the given circuit?

A. 32.2 mA
B. 16 mA
C. 12 mA
D. 48 mA
Answer» B. 16 mA
318.

What is the total current in the given circuit?

A. 0.28 A
B. 0.399 A
C. 909 A
D. 0.2 A
Answer» B. 0.399 A
319.

Which statement about a series RC circuit is true?

A. The capacitor's voltage drop is in phase with the resistor's voltage drop.
B. The current leads the source voltage.
C. The current lags the source voltage.
D. The resistor voltage lags the current.
Answer» C. The current lags the source voltage.
320.

If the frequency increases in the given circuit, how would the total current change?

A. The total current would increase.
B. The total current would decrease.
C. The total current would remain the same.
D. More information is needed in order to predict how the total current would change.
Answer» B. The total current would decrease.
321.

What is the effect of increasing the resistance in a series RC circuit?

A. There will be no effect at all.
B. The current will increase.
C. The phase shift will decrease.
D. The input voltage will increase.
Answer» D. The input voltage will increase.
322.

Calculate the phase angle in the given circuit.

A. 0
B. 90
C. 22.52
D. 67.48
Answer» E.
323.

What is the phase angle for a parallel circuit consisting of a 500 kHz, 5 Vac source with a 47 pF capacitor, and a 4.7 k resistor in parallel?

A. 55.3
B. 55.3
C. 34.8
D. 34.8
Answer» D. 34.8
324.

What is the phase angle in the given circuit?

A. 14.95
B. 36.88
C. 0
D. 90
Answer» B. 36.88
325.

After which time constant can a capacitor be considered to be fully charged?

A. first
B. third
C. fifth
D. seventh
Answer» D. seventh
326.

You could increase the time constant of an RC circuit by

A. adding a resistor in parallel with the circuit resistance
B. adding a capacitor in parallel with the circuit capacitance
C. increasing the amplitude of the input voltage
D. exchanging the position of the resistor and capacitor in the circuit
Answer» C. increasing the amplitude of the input voltage
327.

What is the total opposition to current in a series RC circuit called?

A. impedance
B. inductance
C. reactance
D. resistance
Answer» B. inductance
328.

As a capacitor is being charged, the voltage across its terminals will:

A. increase
B. decrease
C. remain the same
D. oppose the source
Answer» B. decrease
329.

After a capacitor has charged for 1 tc, what percentage of current remains in the resistor?

A. 63.2
B. 36.8
C. 13.5
D. 5.0
Answer» C. 13.5
330.

A capacitor stores energy within a dielectric between the conducting plates in the form of:

A. a magnetic field
B. positive voltage
C. negative voltage
D. an electric field
Answer» E.
331.

What do variable capacitors use for dielectric?

A. ceramic, electrolytic, mica, or paper
B. air, ceramic, mica, or plastic
C. ceramic, paper, plastic, or mica
D. mica, ceramic, plastic, or electrolytic
Answer» C. ceramic, paper, plastic, or mica
332.

If a charged capacitor is disconnected from a circuit, it will:

A. immediately discharge
B. recharge
C. remain charged
D. leak the charge
Answer» E.
333.

The component that produces power in an electromagnetic generator is called the

A. armature
B. field winding
C. commutator
D. brush
Answer» B. field winding
334.

What is the magnetomotive force in a 150-turn coil of wire with 2 A flowing through it?

A. 13.33 mAt
B. 300 At
C. 75 At
D. 152 At
Answer» C. 75 At
335.

A Hall effect sensor

A. exists only in theory
B. is a noncontacting magnetic sensor
C. can operate only a few times before failure
D. produces very large voltages
Answer» C. can operate only a few times before failure
336.

In a 20 Vac series RC circuit, if 20 V is read across the resistor and 40 V is measured across the capacitor, the applied voltage is

A. 45 Vac
B. 50 Vac
C. 60 Vac
D. 65 Vac
Answer» B. 50 Vac
337.

Which of the following is the reference vector for parallel RC circuits?

A. <i>R</i>
B. <i>V</i>
C. <i>I</i>
D. <i>X<sub>C</sub></i>
Answer» C. <i>I</i>
338.

What is the voltage drop across R1 in the given circuit?

A. 10 V
B. 4.80 V
C. 4.00 V
D. 5.80 V
Answer» E.
339.

Power that is measured in volt-amperes is called

A. impedance power
B. reactive power
C. true power
D. apparent power
Answer» E.
340.

The polarity of induced voltage while a field is collapsing is

A. independent of the force creating the field
B. opposite to the force creating the field
C. identical to the force creating the field
D. present only if the force is stationary
Answer» C. identical to the force creating the field
341.

Which electromagnetic device has a movable iron core called a plunger?

A. A speaker
B. A dc generator
C. A relay
D. A solenoid
Answer» E.
342.

Which electromagnetic device contains an armature?

A. A speaker
B. A dc generator
C. A relay
D. A solenoid
Answer» C. A relay
343.

Select the equation below that represents the relationship between charge, capacitance, and voltage for a capacitor.

A. Q = CV
B. C = QV
C. <img src="/_files/images/basic-electronics/complete/mca7_1002c1.gif" align="absmiddle">
D. V = IR
Answer» B. C = QV
344.

What is the angle theta value for a 5.6 F capacitor and a 50-ohm resistor in series with a 1.1 kHz, 5 Vac source?

A. 27.3 degrees
B. 62.7 degrees
C. 27.3 degrees
D. 62.7 degrees
Answer» D. 62.7 degrees
345.

Which electromagnetic device uses brushes and a commutator?

A. A speaker
B. A dc generator
C. A relay
D. A solenoid
Answer» C. A relay
346.

What are the effects of moving a closed wire loop through a magnetic field?

A. A voltage is induced in the wire.
B. A current is induced in the wire.
C. The polarity across the wire depends on the direction of motion.
D. All of the above
Answer» E.
347.

What is the current flow through R1, R2, and R3?

A. 1A, 1A, 1A
B. 1A, 2A, 3A
C. 3A, 3A, 3A
D. 3A, 2A, 1A
Answer» B. 1A, 2A, 3A
348.

If the resistance total in a series circuit doubles, current will:

A. be the same
B. be doubled
C. reduce source voltage
D. be halved
Answer» E.
349.

One of the most common applications of a potentiometer is as an adjustable voltage divider, also known as

A. voltage control
B. current control
C. volume control
D. divider control
Answer» D. divider control
350.

What is the dc source voltage?

A. 78 V
B. 39 V
C. 13 V
D. 0 V
Answer» B. 39 V