Explore topic-wise MCQs in Electrical Engineering.

This section includes 159 Mcqs, each offering curated multiple-choice questions to sharpen your Electrical Engineering knowledge and support exam preparation. Choose a topic below to get started.

1.

________ will be least affected due to charge in supply voltage frequency.

A. lectric clock
B. ixer grinder
C. eiling fan
D. oom heater
Answer» E.
2.

________ is invariably used for peak load

A. uclear power plant
B. team turbine plant
C. umped storage plant
D. one of the above
Answer» D. one of the above
3.

For a diesel generating station the useful life is expected to be around

A. 5 to 20 years
B. 0 to 50 years
C. 0 to 75 years
D. 5 to 100 years
Answer» B. 0 to 50 years
4.

Power plant is expected to have the longest life.

A. team
B. iesel
C. ydroelectric
D. ny of the above
Answer» D. ny of the above
5.

Load curve helps in deciding

A. otal installed capacity of the plant
B. izes of the generating units
C. perating schedule of generating units
D. ll of the above
Answer» E.
6.

Is the reserved generating capacity available for service under emergency conditions which is not kept in operation but in working order,

A. ot reserve
B. old reserve
C. pinning reserve
D. irm power
Answer» C. pinning reserve
7.

In which?of the following power plants the maintenance cost is usually high?

A. uclear power plant
B. ydro-electric power plants
C. hermal power plants
D. iesel engine power plants
Answer» D. iesel engine power plants
8.

A consumer has to pay lesser fixed charges in

A. lat rate tariff
B. wo part tariff
C. aximum demand tariff
D. ny of the above
Answer» D. ny of the above
9.

Low power factor is usually not due to

A. rc lamps
B. nduction motors
C. luorescent tubes
D. ncandescent lamp
Answer» E.
10.

public sector undertaking is associated with erection and sometimes running of thermal power plants

A. TPC
B. AIL
C. EL
D. HEL
Answer» B. AIL
11.

Generating capacity connected to the bus bars and ready to take load when switched on is known as

A. irm power
B. old reserve
C. ot reserve
D. pinning reserve
Answer» E.
12.

Load factor of a power station is defined as

A. aximum demand/average load
B. verage load x maximum demand
C. verage load/maximum demand
D. average load x maximum demand)172
Answer» D. average load x maximum demand)172
13.

Which of the following, in a thermal power plant, is not a fixed cost?

A. uel cost
B. nterest on capital
C. epreciation
D. nsurance charges
Answer» B. nterest on capital
14.

For which of the following power plants highly skilled engineers are required for running the plants?

A. uclear power plants
B. as turbine power plants
C. olar power plants
D. ydro-electric power plants
Answer» B. as turbine power plants
15.

For the same cylinder dimensions and speed, which of the following engine will produce least power?

A. upercharged engine
B. iesel engine
C. etrol engine
D. ll of the above engines will equal power
Answer» D. ll of the above engines will equal power
16.

The area under a load curve gives

A. verage demand
B. nergy consumed
C. aximum demand
D. one of the above
Answer» C. aximum demand
17.

Which of the following is not a method for estimating depreciation charges?

A. inking fund method
B. traight line method
C. iminishing value method
D. alsey
Answer» E.
18.

A low utilization factor for a plant indicates that

A. lant is used for stand by purpose only
B. lant is under maintenance
C. lant is used for base load only
D. lant is used for peak load as well as base load
Answer» B. lant is under maintenance
19.

Annual depreciation cost is calculated by

A. inkingfund method
B. traight line method
C. oth (A) and (B)
D. one of the above
Answer» D. one of the above
20.

In Hopknison demand rate or two parttariff the demand rate or fixed charges are

A. ependent upon the energy consumed
B. ependent upon the maximum demand of the consumer
C. oth (A) and (B)
D. either (A) nor (B)
Answer» C. oth (A) and (B)
21.

By the use of which of the following power factor can be improved ?

A. hase advancers
B. ynchronous compensators
C. tatic capacitors
D. ny of the above
Answer» E.
22.

Annual instalment towards depreciation reduces as rate of interest increases with

A. inking fund depreciation
B. traight line depreciation
C. educing balances depreciation
D. one of the above
Answer» B. traight line depreciation
23.

Which plant can never have 100 percent load factor ?

A. eak load plant
B. ase load plant
C. uclear power plant
D. ydro electric plant
Answer» B. ase load plant
24.

_______ industry has the least power consumption per tonne of product.

A. oap
B. ugar
C. egetable oil
D. austic soda
Answer» D. austic soda
25.

In two part tariff, variation in load factor will affect

A. ixed charges
B. perating or running charges
C. oth (A) and (B)
D. ither (A) or (B)
Answer» C. oth (A) and (B)
26.

In a distribution system, in order to improve power factor, the synchronous capacitors are installed

A. t the receiving end
B. t the sending end
C. ither (A) or (B)
D. one of the above
Answer» B. t the sending end
27.

Which of the following is the disadvantage of a synchronous condenser ?

A. igh maintenance cost
B. ontinuous losses in motor
C. oise
D. ll of the above
Answer» E.
28.

The primary reason for low power factor is supply system is due to installation of

A. nduction motors
B. ynchronous motors
C. ingle phase motors
D. .c. motors
Answer» B. ynchronous motors
29.

which of the following plants ?

A. ase load plants
B. eak load plants
C. oth (A) and (B)
D. one of the above
Answer» C. oth (A) and (B)
30.

During load shedding

A. ystem power factor is changed
B. ome loads are switched off
C. ystem voltage is reduced
D. ystem frequency is reduced Efficiency is the secondary consideration in
Answer» C. ystem voltage is reduced
31.

Annual operating expenditure of a power plant consists of

A. ixed charges
B. emi-fixed charges
C. unning charges
D. ll of the above
Answer» E.
32.

The efficiency of a plant is of least concern when it is selected as

A. eak load plant
B. asual run plant
C. ither (A) or (B)
D. ase load plant
Answer» D. ase load plant
33.

Approximate estimation of power demand can be made by

A. oad survey method
B. tatistical methods
C. athematical method
D. ll of the above
Answer» E.
34.

Large capacity generators are invariably

A. ater cooled
B. atural air cooled
C. orced air cooled
D. ydrogen cooled
Answer» E.
35.

In ______ fuel transportation cost is least.

A. uclear power plants
B. iesel generating plants
C. team power stations
D. one of the above
Answer» B. iesel generating plants
36.

Which of the following plants is almost inevitably used as base load plant ?

A. iesel engine plant
B. as turbine plant
C. uclear power plant
D. umped storage plant
Answer» D. umped storage plant
37.

Can generate power at unpredictable or uncontrolled times,

A. olar power plant
B. idal power plant
C. ind power plant
D. ny of the above
Answer» E.
38.

Salvage value of the plant is always

A. ositive
B. egative
C. ero
D. ny of the above
Answer» E.
39.

Which of the following is not an operating cost ?

A. aintenance cost
B. uel cost
C. alaries of high officials
D. alaries of operating staff
Answer» D. alaries of operating staff
40.

A company can raise funds through

A. ixed deposits
B. hares
C. onds
D. ny of the above
Answer» E.
41.

Maximum demand on a power plant is

A. he greatest of all ?short time interval averaged? demand during a period
B. nstantaneous maximum value of kVA supplied during a period
C. oth (A) or (B)
D. one of the above
Answer» B. nstantaneous maximum value of kVA supplied during a period
42.

In an interconnected system, the diversity factor of the whole system

A. emains unchanged
B. ecreases
C. ncreases
D. one of the above
Answer» D. one of the above
43.

Direct conversion of heat into electrical energy is possible through

A. uel cells
B. olar cells
C. HD generators
D. one of the above
Answer» D. one of the above
44.

Direct conversion of heat into electric power is possible through

A. uel cell
B. atteries
C. hermionic converter
D. ll of the above
Answer» D. ll of the above
45.

Which lightening stroke is most dangerous ?

A. irect stroke on line conductor
B. ndirect stroke on conductor
C. irect stroke on tower top
D. irect stroke on ground wire
Answer» B. ndirect stroke on conductor
46.

Demand factor is defined as

A. verage load/maximum load
B. aximum demand/connected load
C. onnected load/maximum demand
D. verage load x maximum load
Answer» C. onnected load/maximum demand
47.

Which of the following is the disadvantage of static capacitor for power factor improvement ?

A. asily damaged by high voltage
B. annot be repaired
C. hort service life
D. ll of the above
Answer» E.
48.

Which of the following is an advantage of static capacitor for power factor improvement ?

A. ittle maintenance cost
B. ase in installation
C. ow losses
D. ll of the above
Answer» E.
49.

For a consumer the most economical power factor is generally

A. .5 lagging
B. .5 leading
C. .95 lagging
D. .95 leading
Answer» D. .95 leading
50.

An alternator coupled to a _____ runs at slow speed, as compared to as compared to others.

A. iesel engine
B. ydraulic turbine
C. team turbine
D. as turbine
Answer» C. team turbine