

MCQOPTIONS
Saved Bookmarks
This section includes 595 Mcqs, each offering curated multiple-choice questions to sharpen your Chemical Engineering knowledge and support exam preparation. Choose a topic below to get started.
201. |
__________ paper is used in the manufacture of newsprint paper. |
A. | Groundwood |
B. | Board |
C. | Tissue |
D. | Wrapping |
Answer» B. Board | |
202. |
Main constituents of natural rubber is |
A. | polystyrene |
B. | polyisoprene |
C. | polybutadiene |
D. | polychloroprene |
Answer» C. polybutadiene | |
203. |
Sulphur removal by heating of pyrite ore in presence of air is called its |
A. | reduction |
B. | roasting |
C. | calcination |
D. | smelting |
Answer» C. calcination | |
204. |
The yield of tar from high temperature carbonisation of dry coal is about __________ percent. |
A. | 3 |
B. | 12 |
C. | 22 |
D. | 0.3 |
Answer» B. 12 | |
205. |
Na2CO3.10H2O is called |
A. | washing soda |
B. | soda ash |
C. | slaked lime |
D. | quicklime |
Answer» B. soda ash | |
206. |
Oxygen is produced by fractionation of air using __________ process. |
A. | Linde's |
B. | Claude's |
C. | either (a) or (b) |
D. | none of these |
Answer» D. none of these | |
207. |
Bisphenol A is produced by the condensation of acetone with |
A. | formaldehyde |
B. | ethyl alcohol |
C. | diethyl ether |
D. | phenol |
Answer» E. | |
208. |
Raw materials required for the manufacture of __________ is acetylene and hydrochloric acid. |
A. | phthalic anhydride |
B. | vinyl chloride |
C. | maleic anhydride |
D. | dacron |
Answer» C. maleic anhydride | |
209. |
Digestion of wood-base materials (for manufacture of pulp) is done to |
A. | remove lignin. |
B. | produce long fibres. |
C. | prevent deterioration on storage. |
D. | none of these. |
Answer» B. produce long fibres. | |
210. |
Sucrose is a disaccharide consisting of |
A. | glucose and glucose |
B. | glucose and fructose |
C. | glucose and galactose |
D. | fructose and galactose |
Answer» C. glucose and galactose | |
211. |
Cellulose percentage in bamboo fibre is about |
A. | 10 |
B. | 20 |
C. | 50 |
D. | 85 |
Answer» D. 85 | |
212. |
__________ is produced using molasses as the starting raw material. |
A. | Methyl alcohol |
B. | Ethyl alcohol |
C. | Benzol |
D. | Dimethyl ether |
Answer» C. Benzol | |
213. |
Higher vicosity index of a lubricating oil denotes |
A. | less changes in fluidity of oil with temperature. |
B. | substantially high change in fluidity of oil with temperature. |
C. | its unsuitability under varying temperature conditions . |
D. | none of these. |
Answer» B. substantially high change in fluidity of oil with temperature. | |
214. |
Phthalic anhydride is used |
A. | in making PVC |
B. | as plasticisers |
C. | in insecticides manufacture |
D. | for making nylon-6 |
Answer» C. in insecticides manufacture | |
215. |
Main product in calcium carbide-water reaction is |
A. | Ca(OH)2 |
B. | C2H2 |
C. | CO2 |
D. | CaCO3 |
Answer» C. CO2 | |
216. |
Thorium is mainly used |
A. | for the manufacture of gas mantles. |
B. | as a fissile fuel in a nuclear reactor. |
C. | in the manufacture of hydrogen bomb. |
D. | in the treatment of cancer. |
Answer» B. as a fissile fuel in a nuclear reactor. | |
217. |
Massacuits is a terminology used in the __________ industry. |
A. | paint |
B. | oil hydrogenation |
C. | soap |
D. | sugar |
Answer» E. | |
218. |
Alum [Al2(SO4)3] is used as a coagulant in water treatment to remove |
A. | colour |
B. | turbidity |
C. | bacteria |
D. | all (a), (b) and (c) |
Answer» E. | |
219. |
Potassium is kept & transported under |
A. | water |
B. | liquid ammonia |
C. | kerosene oil |
D. | alcohol |
Answer» D. alcohol | |
220. |
Which of the following is a disacchride ? |
A. | Sucrose |
B. | Glucose |
C. | Starch |
D. | Maltose |
Answer» B. Glucose | |
221. |
Dehydrogenation of isopropanol produces |
A. | propyl alcohol |
B. | acetone |
C. | trichloroethylene |
D. | formaldehyde |
Answer» C. trichloroethylene | |
222. |
Fumigant insecticides |
A. | kill insects, when they eat it. |
B. | emit poisonous vapour. |
C. | are absorbed throughout the plant. |
D. | none of these. |
Answer» C. are absorbed throughout the plant. | |
223. |
Le-Blanc process is a primitive process for the manufacture of |
A. | caustic soda |
B. | soda ash |
C. | bromine from sea water |
D. | hydrochloric acid |
Answer» C. bromine from sea water | |
224. |
The major constituent of black liquor generated during paper manufacture is sodium |
A. | sulphate |
B. | carbonate |
C. | hydroxide |
D. | bi-carbonate |
Answer» C. hydroxide | |
225. |
Titanium dioxide is a/an __________ colour pigment. |
A. | white |
B. | black |
C. | yellow |
D. | blue |
Answer» B. black | |
226. |
Oxygen is separated by distillation from air after its liquefaction. The boiling point of oxygen is about __________ °C.$ |
A. | -83 |
B. | -183 |
C. | -196 |
D. | -218 |
Answer» C. -196 | |
227. |
Chemical formula of oleum is |
A. | H2SO3 |
B. | H2SO4 |
C. | H2S2O7 |
D. | H2SO7 |
Answer» D. H2SO7 | |
228. |
__________ is an ore concentrating metallurgical process involving a chemical change. |
A. | Electromagnetic separation |
B. | Froth floatation |
C. | Roasting |
D. | none of these |
Answer» D. none of these | |
229. |
Setting of plaster of paris is accompanied with |
A. | hydration |
B. | dehydration |
C. | hydrolysis |
D. | loss of CO2 |
Answer» B. dehydration | |
230. |
Which of the following is used as a coagulant in water treatment ? |
A. | Chloramine |
B. | Chlorine |
C. | Ferrous sulphate |
D. | Hydrogen peroxide |
Answer» D. Hydrogen peroxide | |
231. |
Temporary hardness of water can be removed by |
A. | addition of alum (a coagulant). |
B. | boiling. |
C. | filtration (through gravity sand filter). |
D. | addition of lime. |
Answer» C. filtration (through gravity sand filter). | |
232. |
Sulphuric acid is mainly used in the __________ industry. |
A. | fertiliser |
B. | steel |
C. | paper |
D. | paint |
Answer» B. steel | |
233. |
Liquefaction of gases can not be done by |
A. | exchange of heat with colder stream. |
B. | adiabatic expansion through a throttle valve (Joule-Thomson expansion). |
C. | merely compressing it beyond critical pressure. |
D. | adiabatic expansion against a piston or in a turbine. |
Answer» D. adiabatic expansion against a piston or in a turbine. | |
234. |
The main aim behind cooling the digested chip at the bottom portion of the digestor by injecting cold black liquor is to |
A. | avoid mechanical weakening of fibre. |
B. | remove lignin by way of crystallisation. |
C. | increase the cellulose content. |
D. | none of these. |
Answer» B. remove lignin by way of crystallisation. | |
235. |
Phthalic anhydride is produced by the oxidation of |
A. | naphthalene |
B. | benzene |
C. | toluene |
D. | aniline |
Answer» C. toluene | |
236. |
Which of the following coals has the highest calorific value ? |
A. | Lignite |
B. | Sub-bituminous |
C. | Anthracite |
D. | Peat |
Answer» D. Peat | |
237. |
Electrodeposition of metals i.e. electroplating is never done on |
A. | metals |
B. | alloys |
C. | refractories |
D. | non-metals |
Answer» D. non-metals | |
238. |
Cement setting under water employs a/an __________ process. |
A. | hydration |
B. | decomposition |
C. | oxidation |
D. | reduction |
Answer» B. decomposition | |
239. |
Dacron (or terylene) fibres as compared to nylon'fibres have |
A. | better heat & acid resistant properties. |
B. | poorer resistance to alkalis. |
C. | poorer dyeability. |
D. | all (a), (b) and (c). |
Answer» E. | |
240. |
Paper grade bamboo contains about __________ percent cellulose. |
A. | 5 |
B. | 20 |
C. | 40 |
D. | 60 |
Answer» B. 20 | |
241. |
Which one of the following is not likely to be a constituent of vegetable oils ? |
A. | Citric acid |
B. | Oleic acid |
C. | Stearic acid |
D. | Glycerol |
Answer» B. Oleic acid | |
242. |
A cane sugar factory having sugar production rate of 10 tons/day will produce about __________ tons/day of bagasse (after consumption by the factory for heating etc.). |
A. | 1 |
B. | 10 |
C. | 25 |
D. | 40 |
Answer» C. 25 | |
243. |
Alcohol is produced by the |
A. | oxidation of an aldehyde |
B. | hydrolysis of an ether |
C. | esterification of a fat |
D. | none of these |
Answer» C. esterification of a fat | |
244. |
Reaction of an alcohol with organic acid is called the __________ reaction. |
A. | saponification |
B. | esterification |
C. | neutralisation |
D. | acidification |
Answer» C. neutralisation | |
245. |
Pick out the false statement pertaining to water treatment. |
A. | Aeration of water is effective in CO2 removal. |
B. | The zeolite water softening process reduces the hardness of water by not more than 50%. |
C. | Sodium sulphate or sodium carbonate do not cause hardness in water. |
D. | Water with pH value less than 7, is acidic. |
Answer» C. Sodium sulphate or sodium carbonate do not cause hardness in water. | |
246. |
Hydrolysis of sugar is called |
A. | hydration |
B. | inversion |
C. | esterification |
D. | none of these |
Answer» C. esterification | |
247. |
Builders are added in soap to act as |
A. | cleaning power booster |
B. | anti-redeposition agent |
C. | corrosion inhibitor |
D. | fabric brightener |
Answer» B. anti-redeposition agent | |
248. |
Yeast is used in the manufacture of |
A. | pencillin |
B. | antibiotics |
C. | wine |
D. | pasteurised milk |
Answer» D. pasteurised milk | |
249. |
Hydrogenation of oil/fat does not |
A. | improve its resistance to rancid oxidation. |
B. | raise its melting point. |
C. | remove double bonds. |
D. | none of these. |
Answer» E. | |
250. |
Analgesic drugs are |
A. | pain relievers |
B. | antibiotics |
C. | used in the treatment of T.B. |
D. | used in the treatment of typhiod |
Answer» B. antibiotics | |