Explore topic-wise MCQs in Forming.

This section includes 15 Mcqs, each offering curated multiple-choice questions to sharpen your Forming knowledge and support exam preparation. Choose a topic below to get started.

Explore topic-wise MCQs in Forming.

In metal forming processes, the temperature rise also depends on the rate of deformation of the material.

In general, the coefficient of friction is very low in the metal forming processes.

The extent of plastic deformation of material is mainly dependent on its grain structure.

The mechanical strength of the metal decreases due to the strain hardening of the metal.

Which of the following can help in determining the behaviour of the material in metal forming?

IN_GENERAL,_THE_COEFFICIENT_OF_FRICTION_IS_VERY_LOW_IN_THE_METAL_FORMING_PROCESSES.?$

In_metal_forming_processes,_the_temperature_rise_also_depends_on_the_rate_of_deformation_of_material.$

The extent of plastic deformation of material is mainly dependent on its grain structure?

In cold forming process, the fuel cost is very less as compared to that in the hot forming process.

Better accuracy and surface finish is achieved by performing hot forming process instead of the cold forming process.

By keeping the metal at higher temperature, its ductility increases with the decrease in its strength.

The mechanical strength of the metal decreases due to strain hardening of the metal.

Flow stress is defined as the instantaneous value of stress required to continue the deformation of metal.

A general stress-strain curve of any material represents the plasticity below the yield point.

Which of the following can help in determining the behaviour of material in metal forming?