IN_GENERAL,_THE_COEFFICIENT_OF_FRICTION_IS_VERY_LOW_IN_THE_METAL_FORMI – McqOptions

MCQOPTIONS

1.	IN_GENERAL,_THE_COEFFICIENT_OF_FRICTION_IS_VERY_LOW_IN_THE_METAL_FORMING_PROCESSES.?$
A.	True
B.	False
Answer» C.

Discussion

No Comment Found

Related MCQs

In metal forming processes, the temperature rise also depends on the rate of deformation of the material.
In general, the coefficient of friction is very low in the metal forming processes.
The extent of plastic deformation of material is mainly dependent on its grain structure.
The mechanical strength of the metal decreases due to the strain hardening of the metal.
Which of the following can help in determining the behaviour of the material in metal forming?
IN_GENERAL,_THE_COEFFICIENT_OF_FRICTION_IS_VERY_LOW_IN_THE_METAL_FORMING_PROCESSES.?$
In_metal_forming_processes,_the_temperature_rise_also_depends_on_the_rate_of_deformation_of_material.$
The extent of plastic deformation of material is mainly dependent on its grain structure?
In cold forming process, the fuel cost is very less as compared to that in the hot forming process.
Better accuracy and surface finish is achieved by performing hot forming process instead of the cold forming process.