Explore topic-wise MCQs in Network Theory.

This section includes 14 Mcqs, each offering curated multiple-choice questions to sharpen your Network Theory knowledge and support exam preparation. Choose a topic below to get started.

1.

A circuit excited by voltage V has a resistance R which is in series with an inductor and a capacitor connected in parallel. The voltage across the resistor at the resonant frequency is ___________

A. 0
B. ( frac{V}{2} )
C. ( frac{V}{3} )
D. V
Answer» B. ( frac{V}{2} )
2.

For a transmission line, open circuit and short circuit impedances are 10 and 20 . Then characteristic impedance is ____________

A. 100
B. 50
C. 25
D. 200
Answer» E.
3.

A capacitor stores 0.15C at 5 V. Its capacitance is ____________

A. 0.75 F
B. 0.75 F
C. 0.03 F
D. 0.03 F
Answer» D. 0.03 F
4.

A series RC circuit has R = 15 and C = 1 F. The current in the circuit is 5 sin 10t. The applied voltage is _____________

A. 218200 cos (10t 89.99 )
B. 218200 sin (10t 89.99 )
C. 218200 sin (10t)
D. 218200 cos (10t)
Answer» C. 218200 sin (10t)
5.

A 3 phase balanced supply feeds a 3-phase unbalanced load. Power supplied to the load can be measured by ___________

A. 2 Wattmeter and 1 Wattmeter
B. 2 Wattmeter and 3 Wattmeter
C. 2 Wattmeter and 2 Wattmeter
D. Only 3 Wattmeter
Answer» C. 2 Wattmeter and 2 Wattmeter
6.

The impedance of an RC series circuit is 12 at f = 50 Hz. At f = 200 Hz, the impedance will be?

A. More than 12
B. Less than 3
C. More than 3 but less than 12
D. More than 12 but less than 24
Answer» D. More than 12 but less than 24
7.

In an RC series circuit R = 100 and XC = 10 . Which of the following is possible?

A. The current and voltage are in phase
B. The current leads the voltage by about 6
C. The current leads the voltage by about 84
D. The current lags the voltage by about 6
Answer» C. The current leads the voltage by about 84
8.

In an AC circuit, the maximum and minimum values of power factor can be ___________

A. 2 and 0
B. 1 and 0
C. 0 and -1
D. 1 and -1
Answer» C. 0 and -1
9.

The current rating of a cable depends on ___________

A. Length of the cable
B. Diameter of the cable
C. Both length and diameter of the cable
D. Neither length nor diameter of the cable
Answer» C. Both length and diameter of the cable
10.

The electrical energy required to heat a bucket of water to a certain temperature is 10 kWh. If heat losses, are 10%, the energy input is ____________

A. 2.67 kWh
B. 3 kWh
C. 2.5 kWh
D. 3.5 kWh
Answer» B. 3 kWh
11.

The impedance matrices of two, two-port network are given by [3 2; 2 3] and [15 5; 5 25]. The impedance matrix of the resulting two-port network when the two networks are connected in series is ____________

A. [3 5; 2 25]
B. [18 7; 7 28]
C. [15 2; 5 3]
D. Indeterminate
Answer» C. [15 2; 5 3]
12.

A two branch parallel circuit has a 50 resistance and 10 H inductance in one branch and a 1 F capacitor in the second branch. It is fed from 220 V ac supply, at resonance, the input impedance of the circuit is _____________

A. 447.2
B. 500
C. 235.48
D. 325.64
Answer» B. 500
13.

Given I (t) = 10[1 + sin (- t)]. The RMS value of I(t) is ____________

A. 10
B. 5
C. ( sqrt{150} )
D. 105
Answer» D. 105
14.

A capacitor of 110 V, 50 Hz is needed for AC supply. The peak voltage of the capacitor should be ____________

A. 110 V
B. 460 V
C. 220 V
D. 230 V
Answer» D. 230 V