

MCQOPTIONS
Saved Bookmarks
This section includes 15 Mcqs, each offering curated multiple-choice questions to sharpen your Network Theory knowledge and support exam preparation. Choose a topic below to get started.
1. |
The resistance of a thermistor decreases with increases in __________ |
A. | temperature |
B. | circuit |
C. | light control |
D. | sensors |
Answer» C. light control | |
2. |
In the figures given below, Value of RA, RB and RC are 20 Ω, 10 Ω and 10 Ω respectively. The resistances R1, R2 and R3 in Ω are ________ |
A. | 2.5, 5 and 5 |
B. | 5, 2.5 and 5 |
C. | 5, 5 and 2.5 |
D. | 2.5, 5 and 2.5 |
Answer» B. 5, 2.5 and 5 | |
3. |
If A = 3 + j1, then A4 is equal to __________ |
A. | 3.16 ∠18.4° |
B. | 100 ∠73.72° |
C. | 100 ∠18.4° |
D. | 3.16 ∠73.22° |
Answer» C. 100 ∠18.4° | |
4. |
In the circuit shown below, the voltage V will be __________ |
A. | – 3V |
B. | Zero |
C. | 3 V |
D. | 5 V |
Answer» B. Zero | |
5. |
For making a capacitor, the dielectric should have __________ |
A. | High relative permittivity |
B. | Low relative permittivity |
C. | Relative permittivity = 1 |
D. | Relative permittivity neither too high nor too low |
Answer» B. Low relative permittivity | |
6. |
If operator ‘a’ = 1 ∠120°. Then (1 – a) is equal to ____________ |
A. | is equal to ____________a) \(\sqrt{3}\) |
B. | \(\sqrt{3}\)∠-30° |
C. | \(\sqrt{3}\)∠30° |
D. | \(\sqrt{3}\)∠60° |
Answer» C. \(\sqrt{3}\)∠30° | |
7. |
In the circuit given below, RI = 1 MΩ, RO = 10 Ω, A = 106 and VI = 1μV. Then the output voltage, input impedance and output impedance respectively are _________ |
A. | 1 V, ∞ and 10 Ω |
B. | 1 V, 0 and 10 Ω |
C. | 1V, 0 and ∞ |
D. | 10 V, ∞ and 10 Ω |
Answer» B. 1 V, 0 and 10 Ω | |
8. |
An AC source of RMS voltage 20 V with internal impedance ZS = (1+2j) Ω feeds a load of impedance ZL = (7+4j) Ω in the circuit given below. The reactive power is _________ |
A. | 8 VAR |
B. | 16 VAR |
C. | 28 VAR |
D. | 32 VAR |
Answer» C. 28 VAR | |
9. |
For the circuit given below, the current I in the circuit is ________ |
A. | –j1 A |
B. | J1 A |
C. | Zero |
D. | 20 A |
Answer» B. J1 A | |
10. |
For the two circuits shown below, the relation between IA and IB is ________ |
A. | IB = IA + 6 |
B. | IB = IA + 2 |
C. | IB = 1.5IA |
D. | IB = IA |
Answer» D. IB = IA | |
11. |
A 1 μF capacitor is connected to 12 V batteries. The energy stored in the capacitor is _____________ |
A. | 12 x 10-6 J |
B. | 24 x 10-6 J |
C. | 60 x 10-6 J |
D. | 72 x 10-6 J |
Answer» E. | |
12. |
A two branch circuit has a coil of resistance R1, inductance L1 in one branch and capacitance C2 in the second branch. If R is increased, the dynamic resistance is going to ___________ |
A. | Increase |
B. | Decrease |
C. | Remains constant |
D. | May increase or decrease |
Answer» C. Remains constant | |
13. |
D is the distance between the plates of a parallel plate capacitor. The dielectric constants are ∈1 and ∈2 respectively. The total capacitance is proportional to ____________ |
A. | \(\frac{∈_1 ∈_2}{∈_1+∈_2}\) |
B. | ∈1 – ∈2 |
C. | \(\frac{∈_1}{∈_2}\) |
D. | ∈1 ∈2 |
Answer» B. ∈1 – ∈2 | |
14. |
A capacitor, used for power factor correction in a single phase circuit decreases which of the following? |
A. | Power factor |
B. | Line current |
C. | Both Line current and Power factor |
D. | Neither Line current nor Power factor |
Answer» C. Both Line current and Power factor | |
15. |
Branch current and loop current relation is expressed in matrix form shown below, where Ij represents branch current and Ik represents loop current.[I1; I2; I3; I4; I5; I6; I7; I8] = [0 0 1 0; -1 -1 -1 0; 0 1 0 0; 1 0 0 0; 0 0 -1 -1; 1 1 0 -1; 1 0 0 0; 0 0 0 1] [I1; I2; I3; I4]The rank of the incidence matrix is? |
A. | 4 |
B. | 5 |
C. | 6 |
D. | 8 |
Answer» B. 5 | |