_ Your switch has a port status LED that is alternating between green and amber. What could this indicate?$?

The port is experiencing errors.

The port is in STP blocking mode.

_ Your switch has a port status LED that is alternating between green

1.	_ Your switch has a port status LED that is alternating between green and amber. What could this indicate?$?
A.	The port is experiencing errors.
B.	The port is shut down.
C.	The port is in STP blocking mode.
D.	Nothing; this is normal.
Answer» B. The port is shut down.

Discussion

No Comment Found

Related MCQs

What are the distinct functions of layer 2 switching that increase available bandwidth on the network?1. Address learning2. Routing3. Forwarding and filtering4. Creating network loops5. Loop avoidance6. IP addressing%!
*$_What is the result of segmenting a network with a bridge (switch)?1. It increases the number of collision domains.2. It decreases the number of collision domains.3. It increases the number of broadcast domains.4. It decreases the number of broadcast domains.5. It makes smaller collision domains.6. It makes larger collision domains.?
*$_You want to run the new 802.1w on your switches. Which of the following would enable this protocol??
_ If a switch receives a frame and the source MAC address is not in the MAC address table but the destination address is, what will the switch do with the frame?$?
_ Your switch has a port status LED that is alternating between green and amber. What could this indicate?$?
_What command will display the forward/filter table?$?
_Layer 2 switching provides which of the following?1. Hardware-based bridging (ASIC)2. Wire speed3. Low latency4. Low cost$?
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?1. Switch (config-if) # ip access-group 102. Switch (config-if) # switchport port-security maximum 13. Switch (config) # access-list 10 permit ip host 14. Switch (config-if) # switchport port-security violation shutdown5. Switch (config) # mac-address-table secure?
You have two switches connected together with two crossover cables for redundancy, and STP is disabled. Which of the following will happen between the switches??

_ Your switch has a port status LED that is alternating between green and amber. What could this indicate?$?

Discussion

No Comment Found

Related MCQs

Reply to Comment