You want to run the new 802.1w on your switches. Which of the following would enable this protocol?

Switch# spanning-tree mode rapid-pvst

Switch(config)# spanning-tree mode rapid-pvst

Switch(config)# spanning-tree mode 802.1w

Switch# spanning-tree mode 802.1w

You want to run the new 802.1w on your switches. Which of the followin

1.	You want to run the new 802.1w on your switches. Which of the following would enable this protocol?
A.	Switch(config)# spanning-tree mode rapid-pvst
B.	Switch# spanning-tree mode rapid-pvst
C.	Switch(config)# spanning-tree mode 802.1w
D.	Switch# spanning-tree mode 802.1w
Answer» B. Switch# spanning-tree mode rapid-pvst

Discussion

No Comment Found

Related MCQs

Layer 2 switching provides which of the following?1. Hardware-based bridging (ASIC)2. Wire speed3. Low latency4. Low cost
What is the result of segmenting a network with a bridge (switch)?1. It increases the number of collision domains.2. It decreases the number of collision domains.3. It increases the number of broadcast domains.4. It decreases the number of broadcast domains.5. It makes smaller collision domains.6. It makes larger collision domains.
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?1. Switch (config-if) # ip access-group 102. Switch (config-if) # switchport port-security maximum 13. Switch (config) # access-list 10 permit ip host 14. Switch (config-if) # switchport port-security violation shutdown5. Switch (config) # mac-address-table secure
What are the distinct functions of layer 2 switching that increase available bandwidth on the network?1. Address learning2. Routing3. Forwarding and filtering4. Creating network loops5. Loop avoidance6. IP addressing
What command will display the forward/filter table?
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure
Layer 2 switching provides which of the following? Hardware-based bridging (ASIC) Wire speed Low latency Low cost
Your switch has a port status LED that is alternating between green and amber. What could this indicate?
You want to run the new 802.1w on your switches. Which of the following would enable this protocol?
If a switch receives a frame and the source MAC address is not in the MAC address table but the destination address is, what will the switch do with the frame?

You want to run the new 802.1w on your switches. Which of the following would enable this protocol?

Discussion

No Comment Found

Related MCQs

Reply to Comment