You need to gather the IP address of a remote switch that is located i – McqOptions

MCQOPTIONS

1.	You need to gather the IP address of a remote switch that is located in Hawaii. What can you do to find the address?
A.	Issue the show ip arp command on the router connected to the switch.
B.	Issue the show ip route command on the router connected to the switch.
C.	Issue the show cdp neighbor command on the router connected to the switch.
D.	Issue the show cdp neighbors detail command on the router connected to the switch.
Answer» E.

Discussion

No Comment Found

Related MCQs

You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requirements for the command to be successful?
What information is displayed by the command?
What does the command provide?
Which three commands can be used to check LAN connectivity problems on a router?1. show interfaces2. show ip route3. tracert4. ping5. dns lookups
You are unsuccessful in telnetting into a remote device. What could the problem be?1. IP addresses are incorrect.2. Access control list is filtering Telnet.3. There is a defective serial cable.4. The VTY password is missing.
What information is displayed by the show hosts command?1. Temporary DNS entries2. The names of the routers created using the hostname command3. The IP addresses of workstations allowed to access the router4. Permanent name-to-address mappings created using the ip host command5. The length of time a host has been connected to the router via Telnet
You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. What IOS user exec command should you issue?
You need to gather the IP address of a remote switch that is located in Hawaii. What can you do to find the address?
Which command loads a new version of the Cisco IOS into a router?
The configuration register setting of 0x2102 provides what function to a router?