You connect a host to a switch port, but the new host cannot log into – McqOptions

MCQOPTIONS

1.	You connect a host to a switch port, but the new host cannot log into the server that is plugged into the same switch. What could the problem be?%!
A.	The router is not configured for the new host.
B.	The VTP configuration on the switch is not updated for the new host.
C.	The host has an invalid MAC address.
D.	The switch port the host is connected to is not configured to the correct VLAN membership.
Answer» E.

Discussion

No Comment Found

Related MCQs

Which of the following is an IEEE standard for frame tagging?%!
You connect a host to a switch port, but the new host cannot log into the server that is plugged into the same switch. What could the problem be?%!
*/*_Which switching technology reduces the size of a broadcast domain??
*/*_What VTP mode allows you to change VLAN information on the switch??
<p>_ Which of the following protocols are used to configure trunking on a switch?1. VLAN Trunk Protocol2. VLAN3. 802.1Q4. ISL$?</p>
_ Which of the following commands sets a trunk port on a 2960 switch?$?
_ You want to improve network performance by increasing the bandwidth available to hosts and limit the size of the broadcast domains. Which of the following options will achieve this goal?$?
_ Which of the following protocols are used to configure trunking on a switch?1. VLAN Trunk Protocol2. VLAN3. 802.1Q4. ISL$?
_Which of the following is true regarding VTP?$?
To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met?1. Each end of the trunk link must be set to the IEEE 802.1e encapsulation.2. The VTP management domain name of both switches must be set the same.3. All ports on both the switches must be set as access ports.4. One of the two switches must be configured as a VTP server.5. A rollover cable is required to connect the two switches together.6. A router must be used to forward VTP traffic between VLANs.$?