While designing the distribution sub stations by the designer, it is required to use the _______ for the discrete power tapping.

While designing the distribution sub stations by the designer, it is

1.	While designing the distribution sub stations by the designer, it is required to use the _______ for the discrete power tapping.
A.	distributor
B.	power transformer
C.	distribution transformer
D.	feeder
Answer» B. power transformer

Discussion

No Comment Found

Related MCQs

For the given distribution system the maximum voltage at the midpoint will be ________
For the single phase 2-wire system, the maximum voltage between the outer wires and earth is ______________
A DC 2-wire system with mid-point earthed having cross-sectional area of each conductor be ‘a’ and resistance ‘R1’. If this is replaced by monopolar system, then saving of copper will be ______
While designing the distribution sub stations by the designer, it is required to use the _______ for the discrete power tapping.
A DC 2-wire system with mid-point earthed having cross-sectional area of each conductor be ‘a’ and resistance ‘R1’. If the DC tow wire replaces the system, then the ratio of volume of each conductor V1/V2 will be ___________
For the figure shown, having a 2-wire dc system where mid point is unearthed, having resistance of 20 ohms, with a power transmitted of 5 MW at the voltage level of 440 kV.The power loss of the distribution system will be ___________
For the figure shown, having a 2-wire dc system where mid point is earthed, having resistance of 20 ohms, with a power transmitted of 5 MW at the voltage level of 440 kV.The power loss of the distribution system will be ___________
A _________ distribution system is more reliable than the ______ distribution system.
While designing the distribution to locality of one lac population with medium dense load requirement, we can employ ___________
A transmission and distribution engineer needed to design the sub transmission substation. The tapping component needed will be _______________

While designing the distribution sub stations by the designer, it is required to use the _______ for the discrete power tapping.

Discussion

No Comment Found

Related MCQs

Reply to Comment