For the figure shown, having a 2-wire dc system where mid point is earthed, having resistance of 20 ohms, with a power transmitted of 5 MW at the voltage level of 440 kV.The power loss of the distribution system will be ___________

For the figure shown, having a 2-wire dc system where mid point is ea

1.	For the figure shown, having a 2-wire dc system where mid point is earthed, having resistance of 20 ohms, with a power transmitted of 5 MW at the voltage level of 440 kV.The power loss of the distribution system will be ___________
A.	5165 W
B.	515 kW
C.	10330 W
D.	2583 W
Answer» B. 515 kW

Discussion

No Comment Found

Related MCQs

For the given distribution system the maximum voltage at the midpoint will be ________
For the single phase 2-wire system, the maximum voltage between the outer wires and earth is ______________
A DC 2-wire system with mid-point earthed having cross-sectional area of each conductor be ‘a’ and resistance ‘R1’. If this is replaced by monopolar system, then saving of copper will be ______
While designing the distribution sub stations by the designer, it is required to use the _______ for the discrete power tapping.
A DC 2-wire system with mid-point earthed having cross-sectional area of each conductor be ‘a’ and resistance ‘R1’. If the DC tow wire replaces the system, then the ratio of volume of each conductor V1/V2 will be ___________
For the figure shown, having a 2-wire dc system where mid point is unearthed, having resistance of 20 ohms, with a power transmitted of 5 MW at the voltage level of 440 kV.The power loss of the distribution system will be ___________
For the figure shown, having a 2-wire dc system where mid point is earthed, having resistance of 20 ohms, with a power transmitted of 5 MW at the voltage level of 440 kV.The power loss of the distribution system will be ___________
A _________ distribution system is more reliable than the ______ distribution system.
While designing the distribution to locality of one lac population with medium dense load requirement, we can employ ___________
A transmission and distribution engineer needed to design the sub transmission substation. The tapping component needed will be _______________

For the figure shown, having a 2-wire dc system where mid point is earthed, having resistance of 20 ohms, with a power transmitted of 5 MW at the voltage level of 440 kV.The power loss of the distribution system will be ___________

Discussion

No Comment Found

Related MCQs

Reply to Comment