Which type of fit is used with the block in a wet liner? – McqOptions

MCQOPTIONS

1.	Which type of fit is used with the block in a wet liner?
A.	Slip fit
B.	Press-fit
C.	Friction fit
D.	Hydraulic dilation
Answer» B. Press-fit

Discussion

No Comment Found

Related MCQs

What is the wall thickness in millimeter preferred between cylinder bores in a hybrid liner?
Which of the following results in a decrease in the scuffing near the sealing ring area?
<p>11.Which of the following technique is used to limit the crank formation in a hybrid liner?
What is the percentage of maximum second-order bore distortion in a conventional cast-in liners?
What is the percentage of heat transfer rate in a hybrid liner?
What is the maximum pressure value in the bar of a hybrid liner?
Which of the following is coated outside along with a conventional cast-iron sleeve in a hybrid liner?
Which of the following is not the reason for the breaking of the flange in a wet liner?
Which among the following material is most commonly used in the manufacturing of cylinder liner?
Which type of fit is used with the block in a wet liner?