

MCQOPTIONS
Saved Bookmarks
This section includes 12 Mcqs, each offering curated multiple-choice questions to sharpen your Automotive Engine Auxiliary Systems knowledge and support exam preparation. Choose a topic below to get started.
1. |
How is the voltage of the used spark plug to fire when compared to a new spark plug? |
A. | High voltage |
B. | Less voltage |
C. | Has no effect |
D. | Depends on the current value |
Answer» B. Less voltage | |
2. |
Which is the material used to make the rotor and a cap of the distributor? |
A. | Bakelite |
B. | Ceramic |
C. | Paper |
D. | Wood |
Answer» D. Wood | |
3. |
Which among the following is not a requirement of a good contact breaker? |
A. | Must open and close at the correct time |
B. | Contacts must close without bounce |
C. | Minimum corrosion |
D. | Contacts should open with fling |
Answer» E. | |
4. |
Where is the condenser placed in the ignition circuit? |
A. | Contact breaker |
B. | Distributor housing |
C. | Ballast resistor |
D. | Spark plug |
Answer» C. Ballast resistor | |
5. |
Which of the following is used to store the inertia of the current flowing during the contact period? |
A. | Contact breaker |
B. | Condenser |
C. | Distributor |
D. | Ballast resistor |
Answer» C. Distributor | |
6. |
How can the center electrode make concerning earth to increase the plug life? |
A. | Positive |
B. | Negative |
C. | Short circuit |
D. | Ground |
Answer» C. Short circuit | |
7. |
What is the gap in millimeters in the contact breaker? |
A. | 0.35-0.45 |
B. | 0.5-0.7 |
C. | 0.7-0.9 |
D. | 1-1.5 |
Answer» B. 0.5-0.7 | |
8. |
What is the type of resistor that is used to avoid overheating and to decrease the amount of current in the primary circuit? |
A. | Ballast resistor |
B. | Thermistor |
C. | Photoresistor |
D. | Rheostats |
Answer» B. Thermistor | |
9. |
Which of the following is used as a material for insulation in the ignition coil? |
A. | Metal |
B. | Ceramic |
C. | Paper |
D. | Wood |
Answer» D. Wood | |
10. |
What is the function of the ignition coil which is simply a transformer? |
A. | Step up the current |
B. | Step down the current |
C. | Step down the voltage |
D. | Step up the voltage |
Answer» E. | |
11. |
Which of the following factors spark creating voltage does not depend on? |
A. | The gap and polarity |
B. | Moisture |
C. | Plug insulation |
D. | Engine speed |
Answer» E. | |
12. |
Which of the following is defined as the actual high voltage at which the spark occurs? |
A. | Cut-in voltage |
B. | Saturated voltage |
C. | Breakdown voltage |
D. | Cut-off voltage |
Answer» D. Cut-off voltage | |