Which of the following profiles are used for guide vanes to ensure smo – McqOptions

MCQOPTIONS

1.	Which of the following profiles are used for guide vanes to ensure smooth flow without separation?
A.	Rectangular
B.	Bent Rectangular
C.	Elliptical
D.	Aerofoil
Answer» E.

Discussion

No Comment Found

Related MCQs

In the figure shown below,which of the following angles replace the question mark?
In case of a Medium runner, tan (α1) CANNOT be given by (α1 = Guide vane angle at inlet)?
Which of the following runner types will have the highest vane angle at inlet (β1 value)?
In the velocity diagrams for Francis turbine, which of the following velocity directions is along the blade curvature?
In case of a Medium runner, tan (‚âà√≠¬¨¬±1) CANNOT be given by (‚âà√≠¬¨¬±1 = Guide vane angle at inlet)?$
Which of the following runner types will have the highest vane angle at inlet (‚âà√≠‚Äö√¢¬ß1 value)?$
In which of the following type of runners the velocity of whirl at inlet is greater than the blade velocity?
Which of the following profiles are used for guide vanes to ensure smooth flow without separation?
Why does the cross sectional area of the Spiral casing gradually decrease along the circumference of the Francis turbine from the entrance to the tip?
Which of the following is true in case of flow of water before it enters the runner of a Francis Turbine?