By plotting the C/t values obtained from a thermal death time curve, a – McqOptions

MCQOPTIONS

1.	By plotting the C/t values obtained from a thermal death time curve, a curve is obtained. How is the lethal value obtained from this curve?
A.	Area under the curve
B.	The center point on the x-axis with respect to beginning and end of curve and then extends to the curve
C.	The center point on the x-axis with respect to beginning and end of curve and then extends to the curve
D.	None of the mentioned
Answer» B. The center point on the x-axis with respect to beginning and end of curve and then extends to the curve

Discussion

No Comment Found

Related MCQs

WHEN_A_CUT_IS_10_MINUTES_AND_THE_CALCULATED_PROCESS_WAS_60_MINUTES_AT_116_DEG_C,_THEN_THE_CORRECTED_PROCESS_TIME_IS______?$
For heat penetration considerations for safe processing schedule, the slowest cooling and the fastest heating curves are used to calculate lethal effect of the process.$
Which_of_the_following_factor_does_safe_processing_schedule_depend_upon?$
Statement 1: Corrosion of cans is more complicated than that of tin and iron alone. Depending on whether the tin forms a complex or not, it acts as the anode or cathode.
Statement 1: The swelling of cans takes place due to the release of hydrogen gas.
Statement 1: In low and medium acid foods, spore forming organisms are observed.
Which of the following is required for calculation of process time by Ball‚Äö√Ñ√∂‚àö√ë‚àö¬•s method?$
With respect to thermal death time curve, D value is the unit defined as the combination of time and temperature to bring about a 90% reduction in spoilage organisms.
Statement 1: In thermal death time curve, after plotting C/t values from it, C value should be equal to Co value.
By plotting the C/t values obtained from a thermal death time curve, a curve is obtained. How is the lethal value obtained from this curve?