Which of the following is not a tube drawing method? – McqOptions

MCQOPTIONS

1.	Which of the following is not a tube drawing method?
A.	Sinking
B.	Plugging
C.	Mandrel
D.	Dome
Answer» E.

Discussion

No Comment Found

Related MCQs

Which of the following parameter should be low to get the best result in sheet metal formed part?
In which of the following process, the thickness of the metal undergoing deforming remains same?
For the large reduction in the rod diameter or the commercial application reduction, the nature of circumferential stress on the surface is __________ and _________ in the center axis.
For the large reduction in the rod diameter or the commercial application reduction, the nature of radial stress on the surface is __________ and _________ in the center axis.
For the significant reduction in the rod diameter or the commercial application reduction, the nature of longitudinal stress on the surface is __________ and _________ in the center axis.
For the reduction pass around one percent, the circumferential residual stress on the surface of rod is ___________ and _________ at axis.
For the reduction pass around one percent, the radial residual stress on the surface of rod is ___________ and _________ at axis.
For the reduction pass around one percent, the longitudinal residual stress on the surface of rod is ___________ and _________ at axis.
Which of the following is not a tube drawing method?
The patenting heat treatment is given to every batch and every kind of wire.