Which of the following has the Log mean temperature difference is used – McqOptions

MCQOPTIONS

1.	Which of the following has the Log mean temperature difference is used for corrected LMTD for a Shell and tube Heat Exchanger?
A.	Counter-flow
B.	Parallel Flow
C.	Cross Flow
D.	Split Flow
Answer» B. Parallel Flow

Discussion

No Comment Found

Related MCQs

If we are given F value and R value, which is the only one variable we cannot determine by this information?
What are the axes of the F-curve?
In a shell and tube heat exchanger, in the inner side fluid enters at 15 and leaves at 65 . The shell has oil entering at 105 and leaving at 85 . What is the value of correction factor coefficients R and P?
Which one of the following are correct relation of R and P?<br>(T/t =shell/tube, <sup>1</sup> <sub>2</sub> = inlet/outlet)
In a shell and tube heat exchanger, in the inner side fluid enters at 15 and leaves at 65 . The shell has steam at 1atm. What is the value of corrected LMTD and correction factor?
The value of correction factor can be equal to 1 in most cases of operation.
What is the value of Correction Factor?<br>Find the value from the below F-curve chart where R = 2, P = 0.3.
Why do we use LMTD Correction factor?
What should be the minimum value of LMTD Correction Factor F for steady state operation of the equipment?
Which of the following has the Log mean temperature difference is used for corrected LMTD for a Shell and tube Heat Exchanger?