If we are given F value and R value, which is the only one variable we – McqOptions

MCQOPTIONS

1.	If we are given F value and R value, which is the only one variable we cannot determine by this information?
A.	Value of P
B.	Temperature of inlet and outlet of shell
C.	Temperature of inlet and outlet of tube
D.	Temperature of inlet and outlet of shell and tube
Answer» E.

Discussion

No Comment Found

Related MCQs

If we are given F value and R value, which is the only one variable we cannot determine by this information?
What are the axes of the F-curve?
In a shell and tube heat exchanger, in the inner side fluid enters at 15 and leaves at 65 . The shell has oil entering at 105 and leaving at 85 . What is the value of correction factor coefficients R and P?
Which one of the following are correct relation of R and P?<br>(T/t =shell/tube, <sup>1</sup> <sub>2</sub> = inlet/outlet)
In a shell and tube heat exchanger, in the inner side fluid enters at 15 and leaves at 65 . The shell has steam at 1atm. What is the value of corrected LMTD and correction factor?
The value of correction factor can be equal to 1 in most cases of operation.
What is the value of Correction Factor?<br>Find the value from the below F-curve chart where R = 2, P = 0.3.
Why do we use LMTD Correction factor?
What should be the minimum value of LMTD Correction Factor F for steady state operation of the equipment?
Which of the following has the Log mean temperature difference is used for corrected LMTD for a Shell and tube Heat Exchanger?