Which of the following conditions are needed to properly bias an npn t – McqOptions

MCQOPTIONS

1.	Which of the following conditions are needed to properly bias an npn transistor amplifier?
A.	Forward bias the base/emitter junction and reverse bias the base/collector junction.
B.	Forward bias the collector/base junction and reverse bias the emitter/base junction.
C.	Apply a positive voltage on the n-type material and a negative voltage on the p-type material.
D.	Apply a large voltage on the base.
Answer» B. Forward bias the collector/base junction and reverse bias the emitter/base junction.

Discussion

No Comment Found

Related MCQs

The ___ oscillator takes advantage of the .
In order to sustain oscillations in a feedback oscillator, the gain should be _________ so the product of × equals_______.
approximately equals _______ when a transistor is in saturation.
The power gain () of any transistor amplifier circuit equals the ___________.
If the drain, source, and channel of a MOSFET are all a -type material, and it operates in both modes, this is an -channel D-MOSFET.
In an -type JFET, current will flow when a positive voltage is applied to the drain and a negative voltage is applied to the source.
The of a BJT is the ratio of collector current to emitter current.
A source follower has a voltage gain () of
The signal voltage gain of an amplifier, , is defined as:
The formula used to calculate the approximate ac resistance of the base-emitter diode () is