Which of the below is used as a check for the design of slab thicknes – McqOptions

MCQOPTIONS

1.	Which of the below is used as a check for the design of slab thickness?
A.	Edge temperature stress
B.	Corner temperature stress
C.	Edge load stress
D.	Corner warping stress
Answer» B. Corner temperature stress

Discussion

No Comment Found

Related MCQs

Design the thickness of a rigid pavement slab for a two-way, two-lane National highway in the state of West Bengal. The total two-way traffic is 2500 CVPD at the end of the construction period. The flexural strength of concrete is 45 kg/cm2, modulus of subgrade reaction is 8 kg/cm3, tyre pressure is 8 kg/cm2, the rate of traffic increase is taken as 7.5 %, the spacing of contraction joints is 4.5 m and the width of the slab is 3.5 m. Assume any other data required. The axle load spectrum obtained from a survey is given below:
The IRC method of rigid pavement design consists of the determination of various parameters. Which of the below options represents the order of designing the parameters?
Which of the below represents a safe design?
The trial thickness is considered to be unsafe if the cumulative fatigue life is ______
To calculate the corner stress, the equation by ______ is used.
What is stress ratio?
The states belonging to which zone have the maximum temperature differential?
What is the range of values for flexural strength of concrete?
What would be the design traffic for a National highway design if the following data is available?Present traffic = 2000 CVPDDesign period = 25 yearsRate of traffic growth = 6%
The equation \(f_{cr}=0.49f_{ck}^{0⋅55}\) to find the flexural strength of concrete was given by ______