Which is the correct order of sequential steps for an electric arc fusion technique?A. Pressing of fiber ends for fusion B. Application of heat for smoothening of end-surfacesC. Alignment of broken fiber edges

Which is the correct order of sequential steps for an electric arc fus

1.	Which is the correct order of sequential steps for an electric arc fusion technique?A. Pressing of fiber ends for fusion B. Application of heat for smoothening of end-surfacesC. Alignment of broken fiber edges
A.	A, B, C
B.	B, A, C
C.	C, B, A
D.	C, A, B
Answer» D. C, A, B

Discussion

No Comment Found

Related MCQs

Consider the assertions given below. Which is the correct sequential order of process adopted in glass fiber preparation?A. Drawing of fiberB. Production of pure glassC. Pulling of fiberD. Conversion of pure glass into preform
If a fiber operates at 1400nm with the diameter of about 10 m, n = 1.30, = 0.80% , V = 3.5, then how many modes will it have?
Consider a crystal of ruby laser whose length is 6 cm and the refractive index is 1.8, emits the wavelength of about 0.55 m. What will be the value of number of longitudinal modes?
Which is the correct order of sequential steps for an electric arc fusion technique?A. Pressing of fiber ends for fusion B. Application of heat for smoothening of end-surfacesC. Alignment of broken fiber edges
In an optical fiber, the concept of Numerical aperture is applicable in describing the ability of__________
Which type of fiber optic cable has/have its/their core with the size of about 480 m to 980 m & made up of polymethylmethacrylate (PMMA)?
For a photo-diode with responsivity of 0.50 A/W & optical power of about 12 W, what would be the value of generated photocurrent?
In fiber fault location, the equation of length (l) for time difference (t) is expressed as L = ct / 2n . Which factor in this equation implies that the light travels a length from source to break point and then through another length on the return trip?
Consider the assertions/ characteristics given below. Which type of attenuation measurement technique exhibits these characteristics?1. Necessity of accessing both ends of fiber.2. Measurements corresponding to specific wavelengths.3. Requirement of spectral response over a range of wavelengths.
Speckle pattern is generated due to interference of nodes from a coherent source especially when the coherence time of source is _________ the intermodal dispersion time in the fiber.

Which is the correct order of sequential steps for an electric arc fusion technique?A. Pressing of fiber ends for fusion B. Application of heat for smoothening of end-surfacesC. Alignment of broken fiber edges

Discussion

No Comment Found

Related MCQs

Reply to Comment