When the 8051 is reset and the line is HIGH, the program counter point – McqOptions

MCQOPTIONS

1.	When the 8051 is reset and the line is HIGH, the program counter points to the first program instruction in the:
A.	internal code memory
B.	external code memory
C.	internal data memory
D.	external data memory
Answer» B. external code memory

Discussion

No Comment Found

Related MCQs

The following command will rotate the 8 bits of the accumulator one position to the left: RL A
The following program will cause the 8051 to be stuck in a loop: LOOP: MOV A, #00H JNZ LOOP
The contents of the accumulator after this operation MOV A,#2BH ORL A,00H will be:
This program code will read data from port 0 and write it to port 2, and it will stop looping when bit 3 of port 2 is set: STAT: MOV A, PO MOV P2,A JNB P2.3, STAT
This program code will be executed once: STAT: MOV A, #01H JNZ STAT
The contents of the accumulator after this operation MOV A,#0BH ANL A,#2CH will be
When the 8051 is reset and the line is HIGH, the program counter points to the first program instruction in the:
The following program will receive data from port 1, determine whether bit 2 is high, and then send the number FFH to port 3: READ: MOV A,P1 ANL A,#2H CJNE A,#02H,READ MOV P3,#FFH
This statement will set the address of the bit to 1 (8051 Micro-controller): SETB 01H
This program code will be executed continuously: STAT: MOV A, #01H JNZ STAT