When a transistor is used as a switch, it is stable in which two disti – McqOptions

MCQOPTIONS

1.	When a transistor is used as a switch, it is stable in which two distinct regions?
A.	saturation and active
B.	active and cutoff
C.	saturation and cutoff
D.	none of the above
Answer» D. none of the above

Discussion

No Comment Found

Related MCQs

What are the two types of bipolar junction transistors?
Refer to this figure. Determine the minimum value of V IN from the following that will saturate this transistor.
The dc load line on a family of collector characteristic curves of a transistor shows the
What is (are) common fault(s) in a BJT-based circuit?
A 35 mV signal is applied to the base of a properly biased transistor with an r' e = 8 and R C = 1 k . The output signal voltage at the collector is:
The magnitude of dark current in a phototransistor usually falls in what range?
In what range of voltages is the transistor in the linear region of its operation?
What is the order of doping, from heavily to lightly doped, for each region?
Which of the following is true for an npn or pnp transistor?
Refer to this figure. The value of DC = 100 and V IN = 8 V. Determine I C(sat) .