WHAT_WILL_BE_THE_MASS_FLOW_RATE_OF_WATER,_WHEN_THE_WATER_PRESSURE_IS_4 – McqOptions

MCQOPTIONS

1.	WHAT_WILL_BE_THE_MASS_FLOW_RATE_OF_WATER,_WHEN_THE_WATER_PRESSURE_IS_4000_BAR,_BEING_ISSUED_FROM_AN_ORIFICE_OF_DIAMETER_0.3_MM,_ASSUMING_ALL_RELATED_COEFFICIENTS_TO_BE_1??$
A.	1 kg/min
B.	2.89 kg/min
C.	3.26 kg/min
D.	3.79 kg/min
Answer» E.

Discussion

No Comment Found

Related MCQs

WHAT_WILL_BE_THE_MASS_FLOW_RATE_OF_WATER,_WHEN_THE_WATER_PRESSURE_IS_4000_BAR,_BEING_ISSUED_FROM_AN_ORIFICE_OF_DIAMETER_0.3_MM,_ASSUMING_ALL_RELATED_COEFFICIENTS_TO_BE_1??$
Addition_of_hard_and_sharp_abrasive_particles_into_the_water_jet_can_increase_the_cutting_ability_of_the_jet.$
Assuming no losses, what will be the water jet velocity, when the water pressure is 4000 bar, being issued from an orifice of diameter 0.3 mm?
For which of the following operations, abrasive water jet machining is not used?
Which of the following materials, is not machined using abrasive water jet machining?
In entrained type AWJM, abrasive water jet has a velocity of around _____ m/s.
To stop the dispersion of the water jet in the atmosphere ______ is used.
In pure WJM, commercially pure water is used.
In AJMM, water at _____ MPa is pumped.
Water Jet Machining (WJM) and Abrasive Jet Micromachining (AJMM or AWJM) can be achieved using how many different approaches?