What protocols are used to configure trunking on a switch?1. VLAN Trun – McqOptions

MCQOPTIONS

1.	What protocols are used to configure trunking on a switch?1. VLAN Trunking Protocol2. VLAN3. 802.1Q4. ISL%!
A.	1 and 2
B.	3 and 4
C.	1 only
D.	2 only
Answer» C. 1 only

Discussion

No Comment Found

Related MCQs

What protocols are used to configure trunking on a switch?1. VLAN Trunking Protocol2. VLAN3. 802.1Q4. ISL%!
If you wanted to delete the configuration stored in NVRAM, what would you type?%!
Which command is used to upgrade an IOS on a Cisco router?%!
You have 10 users plugged into a hub running 10Mbps half-duplex. There is a server connected to the switch running 10Mbps half-duplex as well. How much bandwidth does each host have to the server?%!
*/*_You have 10 users plugged into a hub running 10Mbps half-duplex. There is a server connected to the switch running 10Mbps half-duplex as well. How much bandwidth does each host have to the server??
*/*_Which protocol is used to send a destination network unknown message back to originating hosts??
*/*_Which of the following commands will allow you to set your Telnet password on a Cisco router??
*/*_Which one of the following is true regarding VLANs??
*/*_Which class of IP address has the most host addresses available by default??
*/*_Which protocol does Ping use??