What are reasons for creating OSPF in a hierarchical design?1. To decrease routing overhead2. To speed up convergence3. To confine network instability to single areas of the network4. To make configuring OSPF easier

What are reasons for creating OSPF in a hierarchical design?1. To decr

1.	What are reasons for creating OSPF in a hierarchical design?1. To decrease routing overhead2. To speed up convergence3. To confine network instability to single areas of the network4. To make configuring OSPF easier
A.	1, 2 and 3
B.	3 only
C.	3 and 4
D.	2, 3 nd 4
Answer» B. 3 only

Discussion

No Comment Found

Related MCQs

You need the IP address of the devices with which the router has established an adjacency. Also, the retransmit interval and the queue counts for the adjacent routers need to be checked. What command will display the required information?%!
Which type of OSPF network will elect a backup designated router?1. Broadcast multi-access2. Non-broadcast multi-access3. Point-to-point4. Broadcast multipoint%!
Which of the following network types have a designated router and a backup designated router assigned?1. Broadcast2. Point-to-point3. NBMA4. NBMA point-to-point%!
*/*_You get a call from a network administrator who tells you that he typed the following into his router:Router (config) #router ospf 1Router (config-router) #network 10.0.0.0 255.0.0.0 area 0He tells you he still can't see any routes in the routing table. What configuration error did the administrator make??
_ Which of the following protocols support VLSM, summarization, and discontiguous networking?1. RIPv12. IGRP3. EIGRP4. OSPF5. BGP6. RIPv2$?
_If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?$?
Which two of the following commands will place network 10.2.3.0/24 into area 0?1. router eigrp 102. router ospf 103. network 10.0.0.04. network 10.2.3.0 0.0.0.255 area05. network 10.2.3.0 0.0.0.255 area 0?
What are reasons for creating OSPF in a hierarchical design?1. To decrease routing overhead2. To speed up convergence3. To confine network instability to single areas of the network4. To make configuring OSPF easier
Which of the following are true regarding OSPF areas?1. You must have separate loopback interfaces configured in each area.2. The numbers you can assign an area go up to 65,535.3. The backbone area is also called area 0.4. If your design is hierarchical, then you don't need multiple areas.5. All areas must connect to area 0.
Which EIGRP information is held in RAM and maintained through the use of Hello and update packets?1. Neighbor table2. STP table3. Topology table4. DUAL table

What are reasons for creating OSPF in a hierarchical design?1. To decrease routing overhead2. To speed up convergence3. To confine network instability to single areas of the network4. To make configuring OSPF easier

Discussion

No Comment Found

Related MCQs

Reply to Comment