TIMSK register is used for? – McqOptions

MCQOPTIONS

1.	TIMSK register is used for?
A.	knowing the status of the timer count
B.	used for masking the interrupts flags of the Timer0, Timer1 and Timer2
C.	it is used for enabling all the timer interrupts
D.	it is used for resetting the value of the interrupts
Answer» C. it is used for enabling all the timer interrupts

Discussion

No Comment Found

Related MCQs

WHAT_WILL_HAPPEN_IN_THAT_CONDITION,_IF_AN_INTERRUPT_OCCURS_WHILE_THE_MICROCONTROLLER_IS_SERVING_ANY_OTHER_INTERRUPT??$
WHAT_IS_THE_CORRECT_ORDER_OF_PRIORITY_THAT_IS_SET_AFTER_A_CONTROLLER_GETS_RESET??$
BY_DEFAULT,_INT0-INT2_INTERRUPTS_ARE??$
What is the disadvantage of a level triggered pulse?
Which register is responsible for handling all the external hardware interrupts?
Which register is used to make the pulse a level or an edge triggered pulse?
External hardware interrupts are assigned to which pins of the atmega32?
Why normally LJMP instructions are the topmost lines of the ISR?
Is the same address is assigned for the timer0 and timer1 overflow flag in the interrupt vector table of the interrupts?
Which of the following combination is the best to enable the external hardware interrupt 0 of the IE register (assuming initially all bits of the IE register are zero)?