The value of stress concentration for circular hole in a plate subjected to uniform stress of σ is equal to ________

The value of stress concentration for circular hole in a plate subjec

1.	The value of stress concentration for circular hole in a plate subjected to uniform stress of σ is equal to ________
A.	1
B.	4
C.	3
D.	10
Answer» D. 10

Discussion

No Comment Found

Related MCQs

The effect of the stress riser is much more pronounced in a brittle material than a ductile material. Which of the following is not the correct explanation for this behavior?
The following diagram shows a rectangular plate with a circular hole at the ends. The dimension of the plate is shown in the figure. If the ratio of r/h increase, the stress concentration factor Kt will ______________
The following diagram shows a rectangular plate with a circular hole at the ends. The dimension of the plate is shown in the figure. If the ratio of b/r increase, the stress concentration factor Kt will __________
An elliptical hole in a plate as shown in the figure. The value σmax= σϴ = __________
The value of stress concentration for circular hole in a plate subjected to uniform stress of σ is equal to ________
A rectangular plate has circular hole in center as shown in the figure. There are 4 points located in the plate, find out the point where localized stress will be maximum.
In addition to producing the stress concentration, a notch also creates a localized condition of the biaxial or triaxial stress.
The stress concentration is generally expressed by a theoretical stress-concentration factor kt. Generally, Kt is described as the ratio of _________________
A geometrical discontinuity in a body, such as a hole or a notch result in nonuniform distribution of stress at the vicinity of discontinuity. At the region near the discontinuity, the local stress will be higher than normal stress distribution.

The value of stress concentration for circular hole in a plate subjected to uniform stress of σ is equal to ________

Discussion

No Comment Found

Related MCQs

Reply to Comment