THE_USE_OF_STRAIGHT_OR_CURVED_EXTERNAL_GEAR_TEETH_IN_MESH_WITH_INTERNA – McqOptions

MCQOPTIONS

1.	THE_USE_OF_STRAIGHT_OR_CURVED_EXTERNAL_GEAR_TEETH_IN_MESH_WITH_INTERNAL_TEETH_IN_GEAR_AND_SPLINE_COUPLINGS_IS_SPECIFICALLY_EMPLOYED_ACCOMMODATE?$
A.	torsional misalignment
B.	parallel misalignment
C.	angular misalignment
D.	substantial axial movements between shafts
Answer» E.

Discussion

No Comment Found

Related MCQs

THE_USE_OF_STRAIGHT_OR_CURVED_EXTERNAL_GEAR_TEETH_IN_MESH_WITH_INTERNAL_TEETH_IN_GEAR_AND_SPLINE_COUPLINGS_IS_SPECIFICALLY_EMPLOYED_ACCOMMODATE?$
A worm gear set is designed to have pressure angle of 300 which is equal to the helix angle. The efficiency of the worm gear set at an interface friction of 0.05 i?
In case the number of teeth on two bevel gears in mesh is 30 and 60 respectively, then the pitch cone angle of the gear will be
In skew bevel gears, the axes are
For a pair of gears in mesh, pressure angle and module must be different to satisfy the condition of interchangeability and correct gearing.
Lewis equation for design of involute gear tooth predicts the dynamic load capacity of a cantilever beam of uniform strength.