The three basic steps for fixing a failure are ISOLATE, DIAGNOSE, and – McqOptions

MCQOPTIONS

1.	The three basic steps for fixing a failure are ISOLATE, DIAGNOSE, and REPAIR.
A.	1
B.
C.	1
D.
Answer» C. 1

Discussion

No Comment Found

Related MCQs

An internal logic gate that shorts to either +V or ground will cause the inputs or output to be stuck either LOW or FLOATING.
Erratic or unexplained digital circuit activity is often due to _________.
The device that would best aid in open track detection is a(n) ________.
A check of all power supply voltages should be made during the ________ method of troubleshooting.
What is the next step after discovering a faulty gate within an IC?
The time interval between the start of two consecutive pulses is called pulse repetition time.
The results of internal IC failures will usually be noticed during the ______ phase of troubleshooting.
The duty cycle of a pulse is determined by which formula?
The control of digital circuits is usually achieved with _________.
Which device would best aid in shorted track detection?